939010647 - 1084A42 ENGINE OIL PRESSURE WARNING LIGHT SWITCH - R + R

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. 1. Loosen the band and disconnect the condensed oil recirculation pipe from the crankcase sump. 1. Disconnect the electrical connection from the engine oil pressure warning light switch.

	Description	Connector
1	Insufficient engine oil pressure sensor (switch)	See K030 LOW ENGINE OIL PRESSURE SENSOR (SWITCH)

2. Undo and remove the engine oil pressure warning light switch. Refitting ( Removing ) - Replace the engine oil pressure warning light switch in its housing and tighten it to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Switch for engine oil pressure warning light	-	M14	(support side) 2.3 - 2.8	1.9 JTD 8V1.9 JTD 16V2.4 JTD 20V

- Connect the electrical connection to the engine oil pressure warning light switch.- Connect the condensed oil recirculation pipe to the crankcase sump and tighten the band.    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. - Connect the negative battery terminal.- Remove the vehicle from the lift.