3340B30 HOSE TO L/H OR R/H REAR BRAKES (ONE) - R+R - Alfa - 159 - eLearn

939010778 - 3340B30 HOSE TO L/H OR R/H REAR BRAKES (ONE) - R+R

)

The following procedure describes removal/refitting of the hose to the left rear brake, do the same to remove/refit the hose to the right rear brake.

- Position the vehicle on a lift. Op. 4450B06 LEFT REAR WHEEL - R.R - Remove the protective cap from the bleed valve on the brake caliper.- Connect the recovery device (pipe and reservoir) to the brake caliper bleed valve.- Loosen the bleed valve on the brake caliper and wait until the brake-clutch reservoir and pipes drains.1. Undo the connector (1a) and disconnect the rigid pipe from fitting to rear brake (1b), flexible pipe side.2. Withdraw the hose retaining clip.

1. Undo the connector (1a) and remove the hose to the rear brake (1b).

Refitting ( Removing

) 1. Refit the flexible pipe to the rear brake (1a) and connect to the brake caliper by tightening fitting (1b) to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10/M12	1.4 ÷ 1.8

1. Refit the hose retaining clip in its housing.2. Connect the rigid pipe from the fitting to the rear brake (2a), hose side and tighten the connector (2b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10/M12	1.4 ÷ 1.8

Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR Op. 4450B06 LEFT REAR WHEEL - R.R - Remove the vehicle from the lift.