939010792 - 3330B02 PEDAL ASSEMBLY - R.R
 Removing
		(
		Refitting
Removing
		(
		Refitting )
	- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).
		)
	- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).| Description | Connector | |
|---|---|---|
| - | Battery | See A001 BATTERY | 
| Description | Connector | |
|---|---|---|
| 1 | Brake fluid level sensor (switch) | See K025 BRAKE FLUID LEVEL SENSOR (SWITCH) | 

|  | Collect any brake-clutch fluid that comes out. | 

| Description | Connector | |
|---|---|---|
| 1 | Accelerator pedal potentiometer | See K055 ACCELERATOR PEDAL POTENTIOMETER | 
| Description | Connector | |
|---|---|---|
| 2 | Brake pedal switch | See I030 BRAKE PEDAL SWITCH | 


| Description | Connector | |
|---|---|---|
| 1 | Clutch pedal switch | See I031 CLUTCH PEDAL SWITCH | 
|  | Replace the above pin whenever it is removed. | 


 Refitting
		(
		Removing
Refitting
		(
		Removing )
	1. Position the pedal assembly (1a) in its housing and secure it by tightening the nuts (1b) to the recommended torque.
		)
	1. Position the pedal assembly (1a) in its housing and secure it by tightening the nuts (1b) to the recommended torque.| Component | Fastening | dia | Value (daNm) | Validity | 
|---|---|---|---|---|
| Pedal assembly | Nut | M8 | (bodyshell side) 2.2 - 2.6 | 

| Component | Fastening | dia | Value (daNm) | Validity | 
|---|---|---|---|---|
| Brake servo | Bolt | M8 | (pedal assembly side) 2.2 - 2.6 | 
