939005380 - A032 ALARM DOES NOT GO OFF WITH BOOT RELEASE

When the opening of the boot is requested using the remote control or mechanical key, the alarm system does not switch off

In operational mode, the system, on receiving the boot lid opening command, disables the volumetric/anti-tilt external modules and the perimeter protection from the boot switch inlet.

		Test results
1	CHECK USING DIAGNOSTIC EQUIPMENT	All OK	Problems encountered	Operation
	Connect the diagnostic equipment to the body computer node and check, the parameters ambient, that the boot lid status (open or closed) is correctly received.	Move on to Step 4	The status of the boot lid is not received.	Move on to Step 2
2	ELECTRICAL CIRCUIT CHECK	All OK	Problems encountered	Operation
	Check that the electrical connection between the boot lid switch and the body computer node is not broken or insulated.	Move on to Step 3	Electrical connection broken or not insulated.	Proceed with restoring the continuity/insulation of the electrical connection between the boot lid switch and the body computer node    See E7015 ALARM
3	COMPONENT OPERATION CHECK	All OK	Problems encountered	Operation
	Disconnect the connector, body computer node side, and check for the presence of the boot lid open/closed signal    See E7015 ALARM	Move on to Step 4	Boot lid electric switch not working.	Replace the boot lid lock    Op. 7015B10 SINGLE TAILGATE LOCK - R+R OR REPAIR WITH PANEL/PROTECTION REMOVED
4	CHECK ON CORRECT OPERATION	All OK	Problems encountered	Operation
	Check that the fault is no longer present.	End of diagnosis	The fault persists.	Replace the Body Computer Node    Op. 5505A32 BODY COMPUTER - R.R