939010772 - 3340A34 LEFT OR RIGHT REAR WHEEL RPM SENSOR (ONE) - R.R.

Removing ( Refitting )

The following procedure describes the removing-refitting of the left rear wheel rpm sensor, carry out the same operations for the right rear wheel rpm sensor.

- Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

    Op. 4450B06 LEFT REAR WHEEL - R.R 1. Partly release the wheel arch and disconnect the electrical connection for the left rear wheel rpm sensor.

	Description	Connector
1	Left rear wheel sensor for ABS	See K075 LEFT REAR WHEEL SENSOR FOR ABS

1. Release the electrical wiring for the left rear wheel rpm sensor from the intermediate fastenings.2. Undo the bolt (2a) and remove the left rear wheel rpm sensor (2b). Refitting ( Removing ) 1. Position the left rear wheel rpm sensor (1a) in its housing and secure it tightening the bolt (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Rear wheel rpm sensor	Bolt	M6	(steering knuckle side) 0.7 - 1.1

2. Secure the electrical wiring for the left rear wheel rpm sensor to the intermediate fastenings. - Connect the electrical connection for the left rear wheel rpm sensor and place the wheel arch back in its housing.    Op. 4450B06 LEFT REAR WHEEL - R.R - Connect the negative battery terminal.- Remove the vehicle from the lift.