939003622 - J041 LEFT DOOR MIRROR ELECTRICAL ADJUSTMENT NOT WORKING

When the control is operated the left external mirror does not move.

the mirror is adjusted by the Driver''s Door Node according to information from the adjustment joystick located on the door handle.

1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the Examiner diagnostic equipment to the diagnostic connect and check the following at the Driver''s Door Node:In errors ambient that there are no faults In parameters ambient the plausibility of the parameters for joystick (left/right/up/down). In active diagnosis ambient the operation of the mirror movement motors	Move on to Step 3	1. Presence of faults	1. Continue following the instructions for the diagnostic equipment.
			2. Mirror selector joystick parameters (left/right/up/down) not plausible.	2. Move on to Step 2
			3. Adjustment motors not working.	3. Move on to Step 3.
2	MIRROR ADJUSTMENT JOYSTICK OPERATION CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Remove the control panel following the,Op. 7005R40 on the driver''s door side disconnect the connector and check the operation of the joystick following the,Op. 7005RA	Move on to Step 6	Mirror control joystick faulty	Replace the external mirrors control joystickOp. 7005R40
3	ELECTRICAL SYSTEM CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Remove the left rear view mirror    Op. 7005R35 DOOR MIRROR REFLECTOR (ONE), LEFT OR RIGHT - R.R disconnect the connector for the movement motors, remove the Driver''s Door Node and check: the continuity between the connector and the Driver''s Door Node. the presence of the joint supply positive.     See E3032 DOOR MIRROR ADJUSTMENT	Move on to Step 5	1. Electrical connection interrupted.	1. Move on to Step 4
			2. No positive supply.	2. Move on to Step 4
4	ELECTRICAL SYSTEM CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Remove the door panel and check: the continuity between the Driver''s Door Node and the mirror connector; the presence of the joint supply positive.     See E3032 DOOR MIRROR ADJUSTMENT	Move on to Step 5	1. Electrical connection interrupted.	1. Restore the electrical connection    See E3032 DOOR MIRROR ADJUSTMENT
			2. No positive supply.	2. Replace the Driver''s Door Node    Op. 5505A42 CONTROL UNIT (DIGITAL NETWORK NODE) IN DRIVER'S DOOR - R.R.
5	CHECK ON CORRECT OPERATION	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the fault is no longer present.	End of diagnosis	Fault persists.	Replace the rear view mirror.    Op. 7005R35 DOOR MIRROR REFLECTOR (ONE), LEFT OR RIGHT - R.R