939003643 - K038 MILOMETER/TRIP METER FLASHING

At the end of the check, the mileometer/trip counter on the panel begins to flash

1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect an Examiner and check that the Instrument Panel Node is aligned in Control Unit Test, Other System Group and Proxy Alignment Procedure modes.	Move on to Step 8	1. Impossible to carry out Proxy alignment	1. Move on to Step 2
			2. Alignment not carried out	2. Carry out Proxy alignment
2	CHECK INSTRUMENT PANEL	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the installed panel reflects the vehicle specifications (it is not possible to install the panel of a petrol version on a diesel version)	Move on to Step 3	Panel does not correspond to the vehicle specification	Replace instrument panel Op.
3	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the Examiner diagnostic equipment and check, in Instrument Panel Node mode, that there are no errors and that the parameters are present.	Move on to Step 8	1. Impossible to connect to the NQS	1. Move on to Step 4
			2. Presence of errors	2. Move on to Step 7
4	ELECTRICAL POWER SUPPLY CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the Instrument Panel Node elecricity supply is correct    See E4010 INSTRUMENT PANEL	Move on to Step 5	Fault in positive electricity supply and/or earth	Renew and/or replace the defective component (in the case of a fuse, find out what caused it to blow).
5	CHECK ELECTRICAL CONNECTIONS	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the Instrument Panel Node electrical wiring/connections, in particular that each pin is correctly connected and inserted in its seat	Move on to Step 6	Electrical wiring and/or connections not working	Restore the damaged electrical wiring and/or connections
6	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Use an Examiner to check the possibility of connecting to the Instrument Panel Node	Move on to Step 7	Impossible to connect with the control unit	Replace instrument panel Op.
7	CHECK ERRORS	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check for the absence of one or more of the following errors using the Examiner in Instrument Panel Node mode: CAN line EEPROM memory	Move on to Step 8	1. Detected "no additional information" and/or "BUS off"	1. Continue as described by the diagnostic equipment
			2. Fault in EEPROM memory	2. Replace instrument panel Op.
8	ACTIVE DIAGNOSIS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Use an Examiner to check that the Autotest function is correctly activated in Active Diagnosis mode	Move on to Step 9	The function under examination is not controlled by Active Diagnosis	Replace instrument panel Op.
9	CHECK ON CORRECT OPERATION	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the fault is no longer present.	End of diagnosis