939003682 - K144 ONE WARNING LIGHT ACTIVATED BY STEERING COLUMN SWITCH UNIT ON CONSTANTLY

When the lights are deactivated using the stalk, the relevant warning light does not go off on the instrument panel N.B: The warning lights activated when the stalk is operated are:

• Side lights/number plate lights
• Main beam headlamps
• Direction indicators

0	PRELIMINARY CHECKS	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	With the key ON, turn all the lights on and off from the stalk, i.e.: Using the wheel, side lights/number plate lights With the stalk, high beams (both fixed and flashing positions) With the stalk, turn signals (right and left) and check they turn on/off	Move on to Step 1	1. The side lights do not work	1. Continue as instructed in theSee table I001
			2. The high beams do not work	2. Continue as instructed in theSee table I006
			3. The turn signals do not operate on both sides	3. Continue as instructed in theSee table I010
			4. The turn signals do not operate on one side only	4. Continue as instructed in theSee table I012
1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Using the Examiner diagnostic equipment check, in Instrument Panel mode, that there are no errors and that the parameters are present.	Move on to Step 2	Presence of errors	Continue following the instructions on the diagnostic instrument
2	ELECTRICAL POWER SUPPLY CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the electricity supply to the Instrument Panel Node is correct.	Move on to Step 3	Fault in positive electrical supply and/or earth	Replace defective component (in the case of a fuse, find out what caused it to blow).
3	CHECK ELECTRICAL CONNECTIONS	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the electrical connections between the Body Computer and the Instrument Panel. In particular, check that each individual pin is properly connected.	Move on to Step 4	Electrical connections not operational	Renew the damaged electrical connections
4	ACTIVE DIAGNOSIS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	With the Examiner in Instrument Panel Node mode, check that the warning lights in question are correctly activated in Active Diagnosis.	Move on to Step 5	The warning lights do not flash	Replace the Instrument Panel    Op. 5560B10 CONTROL PANEL - R+R
5	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Using the Examiner check, in the Body Computer Node mode, that there are no errors and that the parameters are present.	Move on to Step 6	1. Impossible to connect to the Body Computer control unit.	1. Move on to Step 6
			2. Presence of errors.	2. Continue following the instructions on the diagnostic instrument
			3. The parameters do not change	3. Move on to Step 8
6	ELECTRICAL POWER SUPPLY CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the electricity supply to the Body Computer Node is correct.	Move on to Step 7	Fault in positive electrical supply and/or earth	Replace defective component (in the case of a fuse, find out what caused it to blow).
7	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Use an Examiner to check the possibility of connection to the Body Computer Node	Move on to Step 8	Impossible to connect to the Body Computer control unit.	Replace Body Computer    Op. 5505A32 BODY COMPUTER - R.R
8	CHECK ON CORRECT OPERATION	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the fault is no longer present	End of diagnosis