939003689 - K163 TEG LOCK WARNING LIGHT ON CONSTANTLY

1	PRELIMINARY CHECKS	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the engine has not been switched off by pressing the Start/Stop button with the vehicle speed above 10 km/hCheck that the ignition key has not been released with the insert.	Move on to Step 2	1.The engine has been switched off with the vehicle speed above 10 km/h	1.Delete the errors at the Teg Reader Node using the Examiner
			2.The engine has not been switched off	2.Move on to step 4
			3.The ignition key has been released.	3.Continue following    See table B006 KEY CANNOT BE EXTRACTED FROM BLOCK
			4.The ignition key has not been released.	4.Move on to step 4
2	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Using the Examiner check, in the Instrument Panel Node ambient, that there are no errors and that the parameters are present.	Move on to Step 3	Errors present	Continue as described by the diagnostic equipment
3	ACTIVE DIAGNOSIS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	With the Examiner in the Instrument Panel Node ambient check that the Teg Locked warning light is correctly activated in Active Diagnosis	Move on to Step 4	The warning light does not flash	Replace the Instrument Panel    Op. 5560B10 CONTROL PANEL - R+R
4	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that there are no errors with the Examiner connected at the Teg Reader node.	Move on to Step 5	Errors present	Continue as described by the diagnostic equipment
5	START/STOP BUTTON OPERATION CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the Start/Stop button is working properly by carrying out    See Test 5520GA IGNITION PUSH BUTTON CHECK	End of diagnosis	Start/Stop button defective	Replace the starting button    Op. 5520G30 START/STOP SWITCH FOR EASY-GO SYSTEM STARTER MOTOR - R.R.