| 0 | CHECK THE MAP CD | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
|---|
| Check that the map CD is clean and not scratchedCheck that the CD is compatible with the type of navigation system | Move on to Step 1 | 1. Dirty and scratched | 1. Clean or replace the CD |
| 2. Map CD not compatible with the Connect SW | 2. Replace the map CD with a compatible CD |
| 1 | CHECK SATELLITE RECEPTION | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
|---|
| In NAV mode, check that system indicates reception of at least three satellites See Test 5580PE CHECK THE OPERATION OF THE CONNECT GPS AERIAL MODULE | Move on to Step 2 | No satellite signal coverage | Move to an area covered by the satellite signals |
| 2 | CHECK USING DIAGNOSTIC EQUIPMENT | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
|---|
| Use a tester to check for errors | Move on to Step 3 | 1. Errors are present in the satellite aerial due to- defective satellite aerial connection
| 1. Restore the satellite aerial connection |
| 2.Satellite aerial defective | 2. Replace the satellite aerialOp. 5580M70 |
| 3 | CHECK ON CORRECT OPERATION | ALL OK | PROBLEMS ENCOUNTERED | ACTION |
|---|
| Check while on the road that at least three satellites are correctly connected See Test 5580MC SATELLITE NAVIGATOR OPERATION CHECK | | Fault persists | Replace Connect Op. 5580P12 CONNECT PANEL REPLACE |
