939004858 - 7210B61 R.R. BOOT FLOOR PAN SIDE MEMBER - PARTIAL

Removing ( Refitting )     Op. 7210B82 R.R REAR CROSSMEMBER     Op. 7210B70 R.R. REAR TRIM (STRUCTURAL ELEMENT)     Op. 7210B54 R.R. SPARE WHEEL COMPARTMENT    Op. 7210B58 R.R. BOOT FLOOR CORNER (ONE), LEFT OR RIGHT- Check that the components connected are not distorted by checking the bodyshell alignment measurements using suitable equipment (gauges, templates or jigs).- Straighten the body as necessary. 1. Use the hack saw following the cutting line in the diagram.- Remove the part from the vehicle. - Straighten the edges of the vehicle using a hammer and dolly block.- Use a rotary brush to clean the areas treated previously.1. Apply electro-galvanizing paint. Refitting ( Removing ) 1. Use the hacksaw to cut the part, following the line shown in the figure to adjust to the required size.2. Remove the anti-corrosion treatment from the entire perimeter of the inside and outside of the replacement part using a rotary brush.- Apply electro-weldable paint to the edges involved. 1. Position the replacement part correctly on the vehicle and secure it using self-locking clamps.- Check the alignment and the surrounding gaps.2. Use a MIG welder to seam weld in the join areas. - Correct any distortions to the panel using a mallet and dolly block.1. Use a disc grinder to level the welds.- Use a rotary brush to clean the areas welded previously. 1. Apply anti-oxidant protection to the areas involved in the welding.- Seal the join lines between the replacement part and the vehicle.     Op. 7210B58 R.R. BOOT FLOOR CORNER (ONE), LEFT OR RIGHT    Op. 7210B54 R.R. SPARE WHEEL COMPARTMENT    Op. 7210B70 R.R. REAR TRIM (STRUCTURAL ELEMENT)     Op. 7210B82 R.R REAR CROSSMEMBER