939005393 - I065 DIPPED HEADLAMPS LOWERD AND NOT MOVING

Both the headlamps come on, the initial test is carried out and the remain immobile, facing downwards

1	CHECK ON ALIGNMENT SENSOR WIRING	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the condition of the wiring for the alignment sensors.Check that the alignment sensors are correctly fitted and, in particular, that the fastening of the bracket with the connecting rod is correct	Move on to Step 2	1. Wiring short circuited with +Vbatt or to earth	1. Restore insulation for wiring    See E2011 DIPPED HEADLAMPS
			2. Wiring broken	2. Restore or, if necessary, replace the wiring
			3. Mechanical installation of front sensor (brackets, connecting rods) incorrect	3. Refit front sensor correctly    Op. 5540C42 SENSOR FOR CORRECTING/ALIGNING GAS DISCHARGE LIGHTING UNITS ON FRONT SUSPENSION - R R
			4. Mechanical installation of rear sensor (brackets, connecting rods) incorrect	4. Refit rear sensor correctly    Op. 5540C46 SENSOR FOR CORRECTING/ALIGNING GAS DISCHARGE LIGHTING UNITS ON REAR SUSPENSION - R.R.
2	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that there are no errors by connecting to the master headlamp (left) control unit	End of diagnosis	1. Presence of error detectedB1020 - Front sensor signal	1. Move on to Step 3
			2. Presence of error detectedB1021 - Rear sensor signal	2. Move on to Step 3
			3. Presence of error detectedB1022 - Sensor power supply	3. Move on to Step 3
			4. Presence of error detectedB1030 - Master/Slave communication	4. Move on to Step 4
			5. Presence of error detectedB1040 - Headlamp alignment corrector	5. Move on to Step 5
3	CHECK ON ALIGNMENT SENSORS SUPPLY	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the alignment sensors are receiving a correct supply by carrying out the test    See Test 5540CA HEADLAMP ALIGNMENT SENSOR CHECK	Move on to Step 4
4	BIDIRECTIONAL SERIAL LINE CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the continuity and the insulation of the two-way serial line between the master and slave headlamps, carrying out the test    See Test 5540BL BIDIRECTIONAL SERIAL LINE CHECK	Move on to Step 5
5	CHECK ON CONNECTIONS INSIDE THE HEADLAMPS	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the connections inside the headlamps for the vertical adjustment motors are correctly connected by carrying out the test    See Test 5540BM CHECK THE HEADLAMP ALIGNMENT MOTOR SUPPLY WIRING	Move on to Step 6
6	CHECK ON OPERATION OF HEADLAMP ALIGNMENT ACTUATORS	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Replace the headlamps and check in active diagnosis that the diagnostic equipment activates the correct operation of the actuators	End of diagnosis	1. Right headlamp alignment corrector not working	1. Move on to Step 7
			2. Left headlamp alignment corrector not working	2. Move on to Step 7
7	CHECK ON CORRECT OPERATION	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Refit the headlamps replaced previously and replace the ballast control units.	End of diagnosis	The fault persists	Contact the Service Department for further information on the problem