939010162 - Y046 P0606 - CONTROL UNIT BROKEN (MICROPROCESSOR)

The diagnostic equipment signals: Error P0606 (Control unit broken (microprocessor)).
This error is detected if the control unit recognizes a malfunction in the circuit through an internal logic evaluation.
0Preliminary checksALL OKPROBLEMS ENCOUNTEREDACTION
Select the following system on the diagnostic equipment: Diesel EDC16C39 electronic injection system.Delete the errors present and press the START/STOP button.Wait for the engine management control unit to switch off (min. 20 secs.).
Note: The main relay is switched off.If the engine is very hot, the fans remain on after the ignition is switched off.In this case, the control unit switches off automatically 10 secs after the fans are switched off.
Move on to Step 1
1Errors checkALL OKPROBLEMS ENCOUNTEREDACTION
Drive the vehicle in different driving conditions (engine speed and engine load) for a long stretch.Listen out for any unusual noises and other system irregularities.At the end of the road test, check that none of the following errors is present using the diagnostic equipment:

  • P0335 - Engine rpm sensor, with detail "signal not valid"
  • P0606 - Control unit broken (microprocessor)
  • P1618 – Control unit broken (HW CY940)
End of diagnosis1. The engine is not running smoothly1. Proceed as instructed in the    See table D003 ENGINE NOT RUNNING SMOOTHLY / (IRREGULAR OPERATION)
2. The engine is losing power2. Proceed as instructed in the    See table D004 ENGINE NOT RUNNING SMOOTHLY
3. The engine does not produce maximum performance3. Proceed as instructed in the    See table D005 ENGINE DOES NOT PRODUCE BEST PERFORMANCE
4. The engine response is poor4. Proceed as instructed in the    See table D016 POOR ENGINE RESPONSE
5. There is engine knock5. Proceed as instructed in the    See table S003 ENGINE KNOCKING
6. Error P0335 is present6. Proceed as instructed in the    See Test 1060GI ENGINE SPEED CHECK
7. Error P0606 is present7. Proceed as instructed in the    See Test 1060GK CHECK CONTROL UNIT SOFTWARE AND HARDWARE
8. Error P1618 is present8. Proceed as instructed in the    See Test 1060GL CHECK OPERATION OF MAIN ENGINE CONTROL UNIT RELAY