939010197 - 1060GQ CHECK OPERATION OF SENSOR DETECTING PRESENCE OF WATER IN DIESEL FILTER

STEPCHECK TO BE PERFORMEDRESOLUTION IF THE CHECK IS NOT OK
1Press the START/STOP button and turn off the engine.Clean the diesel filter and replace if necessary    Op. 1044B10 FUEL FILTER ASSEMBLY - R + R OR REPLACE Press the START/STOP button. Select the following system on the diagnostic instrument: Electronic diesel injection system EDC16C39. Check that error P2264 – Water in diesel filter is “Present”Water present in diesel filterCheck there is no water in the fuel tank.Clean the tank if necessary
2Press the START/STOP button.Disconnect the wiring harness connector from the temperature sensor and fuel heater coil and from engine control unit connector A.Press the START/STOP button.Check that the voltage across pin 5 of the control unitSee K100 and the earth is greater than 0.3 V.Repair or if necessary replace the electrical wiring between the water presence sensor and the engine control unit    See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT
3Press the START/STOP button. Check that the resistance across Pin 5 of the sensorSee K100 and the earth is more than 500 kOhm.Repair or if necessary replace the electrical wiring between the water presence sensor and the engine control unit    See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT
4Check that the resistance across pin 5 of the sensorSee K100 and pin 74 of the control unit    See M010 ENGINE MANAGEMENT ECU is less than 5 OhmsRepair or if necessary replace the electrical wiring between the water presence sensor and the engine control unit    See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT
5Connect a shunt cable with fuse between pin 72 of control unit connector A    See M010 ENGINE MANAGEMENT ECU and the earth.Check that the voltage across pin 3 of the control unitSee K100 and the earth is greater than 11 V.Repair or if necessary replace the electrical wiring between the water presence sensor and the engine compartment junction unit    See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT
6Check that the resistance across pin 4 of the sensorSee K100 and the earth is greater than 5 Ohms.Repair or if necessary replace the electrical wiring between the water presence sensor and earth    See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT
7Replace the water presence sensor    Op. 1060G30 WATER PRESENCE SENSOR IN FUEL FILTER - R.R.Repair the original sensor and replace the engine control unit    Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - .R