939010759 - 3310A30 FRONT BRAKE CALIPER (ONE) - R.R

Removing ( Refitting )

The following procedure describes the removing-refitting of the left front brake caliper; the same should be done for the right front brake caliper.

- Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).    Op. 4450B02 LEFT FRONT WHEEL - R.R     Op. 7055B90 LEFT FRONT WHEEL ARCH LINER - R.R.     Op. 3340B10 HOSE TO L/H OR R/H FRONT BRAKES (ONE) - R+R 1. Disconnect the electrical connection for the brake pad wear sensor.

	Description	Connector
1	Left brake pad wear sensor (switch)	See K020 LEFT BRAKE PAD WEAR SENSOR (SWITCH)

There is no brake pad wear sensor on the right front caliper.

2. Undo the bolts (2a) and remove the front brake caliper assembly (2b) with pads. - Working at the bench, remove the brake pads from the caliper. Refitting ( Removing ) - Place the brake pads in their housings on the brake caliper.- Position the rear brake caliper in its housing and secure it tightening the bolts to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Front brake calipers	Bolt	M8	2.5 ÷ 3.0	2.2 JTS 3.2 JTS

- Connect the electrical connection for the brake pad wear sensor.    Op. 3340B10 HOSE TO L/H OR R/H FRONT BRAKES (ONE) - R+R     Op. 7055B90 LEFT FRONT WHEEL ARCH LINER - R.R.     Op. 4450B02 LEFT FRONT WHEEL - R.R     Op. 0010T64 BRAKE AND/OR CLUTCH FLUID CHECK LEVEL AND TOP UP AS NECESSARY     Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR - Connect the negative battery terminal.- Remove the vehicle from the lift.