939005786 - 4110A29 MOUNT WITH STEERING SHAFTS - R R - INCLUDES STEERING WHEEL R R - FOR RIGHT-HAND SIDE VERSIONS

Removing ( Refitting ) - Drain the brake-clutch fluid using a suitable tool.
The above operation is necessary to fully depress the brake pedal during the removal of the bolts securing the steering control shaft support to the dashboard frame.
Follow all the recommended safety instructions.
    Op. 5580C18 AIR BAG MODULE - R+R     Op. 4110A10 STEERING WHEEL - R+R FOR REPLACEMENT OR CHECKS     Op. 5580C23 DRIVE SIDE KNEE PROTECTION AIR BAG MODULE R. R.    Op. 7040A37 FUSE BOX COVER IN INSTRUMENT PANEL - R.R     Op. 5505A43 CONTROL UNIT (DIGITAL NETWORK NODE) IN DRIVER'S DOOR - R.R. WITH PANEL REMOVED 1. Undo the fixing bolt (1a) and disconnect the steering column (1b) from the steering box pinion.
The bolt is the pre-treated type and it therefore cannot be reused when refitting.
Prevent the steering column from turning under all circumstances until the steering column has been refitted to the steering box. Ensure the steering box is located centrally.
1. Unscrew the lower bolt securing the mount with the steering control shafts to the facia.
1. Unscrew the two upper bolts securing the mount with the steering control shafts to the facia.
1. Disconnect the electrical connection from the steering lock node.
DescriptionConnector
1Steering lock control unit (NBS)    See M089 STEERING LOCK CONTROL UNIT (NBS)
1. Remove the support and steering shaft assembly.
Refitting ( Removing ) - Refit the support and steering shaft assembly.- Connect the electrical connection to the steering lock node.1. Tighten the two upper bolts securing the mount with the steering control shafts to the facia to the specified torque.
ComponentFasteningdia  Value (daNm)Validity
Support with steering control shafts.BoltM8(dashboard crossmember side) 2.2 - 2.6
1. Tighten the lower bolt securing the mount with the steering control shafts to the facia to the specified torque.
ComponentFasteningdia  Value (daNm)Validity
Support with steering control shafts.BoltM8(dashboard crossmember side) 2.2 - 2.6
1. Connect the steering column (1a) to the power steering box pinion and secure it by tightening a new bolt (1b) to the specified torque.
ComponentFasteningdia  Value (daNm)Validity
Steering columnBolt (pretreated to be replaced)M8(power assisted steering box side) 2.3 - 2.8
The steering shaft must be positioned in the correct position in relation to the pinion.
If a new mount with steering shafts is fitted, remove the device to prevent the steering column from turning.
    Op. 5505A43 CONTROL UNIT (DIGITAL NETWORK NODE) IN DRIVER'S DOOR - R.R. WITH PANEL REMOVED     Op. 7040A37 FUSE BOX COVER IN INSTRUMENT PANEL - R.R     Op. 5580C23 DRIVE SIDE KNEE PROTECTION AIR BAG MODULE R. R.    Op. 4110A10 STEERING WHEEL - R+R FOR REPLACEMENT OR CHECKS     Op. 5580C18 AIR BAG MODULE - R+R     Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR