939003558 - A035 TILT SENSOR ALARM NOT WORKING

The anti-tilt sensor is located in the courtesy light module and is connected to the Body Computer by means of the dialogue line known as the A-BUS. The tilt sensor is operated and controlled by the Body Computer Node via a series of encrypted messages and can be excluded by the customer using the special button. If there is a failure the Body Computer Node detects and memorizes the causes of the malfunction
Results of the tests
1CHECK USING DIAGNOSTIC EQUIPMENTAll OKProblems encounteredOperation
Connect the diagnostic equipment to the diagnostic socket and check the following at the Body Computer Node in parameters ambient:. the presence of the tilt sensor in the errors ambient:. that there are no problems relating to the tilt sensorMove on to Step 2Tilt sensor excluded manuallySwitch on tilt sensor
Tilt sensor not presentCheck the conformity of the vehicle
Presence of faultsProceed as instructed by the diagnostic tester
2TILT MODULE POWER SUPPLY CHECKAll OKProblems encounteredOperation
Check that the anti-tilt module is correctly supplied    See Test 5580EC ULTRASOUND/ANTI-LIFT MODULE CHECKMove on to Step 3Supply not correctRestore correct power supply
3CHECK USING DIAGNOSTIC EQUIPMENTAll OKProblems encounteredOperation
Connect the diagnostic equipment to the diagnostic socket and check the following at the Body Computer Node. In active diagnosis:. the operation of the tilt module. the condition of the A-Bus serial lineMove on to Step 4A-BUS serial line interruptionRenew serial line    See E7015 ALARM
Anti-tilt module defectiveReplace the courtesy light module with built-in tilt sensor    Op. 5580E50 ANTITHEFT DEVICE VOLUMETRIC SENSOR R R FOLLOWING ELECTRICAL CIRCUIT CHECK
4CHECK ON CORRECT OPERATIONAll OKProblems encounteredOperation
Check that the fault is no longer presentFault persistsBody Computer defectiveReplace Body Computer    Op. 5505A32 BODY COMPUTER - R.R