| | Test results |
| 1 | CHECK USING DIAGNOSTIC EQUIPMENT | All OK | Problems encountered | Operation |
|---|
| Connect the Examiner diagnostic equipment and check, in the parameters ambient, that the status (open/closed) for the doors and the boot lid has been correctly received. | Move on to Step 4 | Error in receiving the door(s) and boot lid status (open/closed). | Move on to Step 2 |
| 2 | ELECTRICAL CIRCUIT CHECK | All OK | Problems encountered | Operation |
|---|
| Check the continuity/insulation of the connection between the body computer node and the door(s) and the boot lid. | Move on to Step 3 | Electrical connection damaged. | Restore the continuity/insulation for the damaged electrical connection See E7015 ALARM |
| 3 | ELECTRICAL COMPONENT OPERATION CHECK | All OK | Problems encountered | Operation |
|---|
| Disconnect the connector, body computer node side, and check for the presence of the door and boot lid status signal (open/closed) See E7015 ALARM | Move on to Step 4 | Door status signalling switch not working | Replace the damaged switch Op. 7005N20 FRONT SIDE DOOR LOCK MOTOR/CATCH ASSEMBLY, LEFT OR RIGHT - R.R WITH DOOR PANEL AND SUPPORT FRAME REMOVED |
| Switch signalling boot lid status not working | Replace the damaged switch Op. 7015B10 SINGLE TAILGATE LOCK - R+R OR REPAIR WITH PANEL/PROTECTION REMOVED |
| Switch signalling bonnet lid status not working | Replace the damaged switch |
| 4 | CHECK ON CORRECT OPERATION | All OK | Problems encountered | Operation |
|---|
| Check that the fault is no longer present. | End of diagnosis | The fault persists. | Replace the Body Computer Node Op. 5505A32 BODY COMPUTER - R.R |
