939010455 - 1032A10 CHAIN GEARS AND TIMING SYSTEM COMPONENTS R R

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

    Op. 1048A28 VACUUM AIR CIRCUIT RESONATOR PIPE - R+R     Op. 4450B04 RIGHT FRONT WHEEL - R.R     Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.     Op. 1092G10 SINGLE ENGINE BELT - R.R     Op. 1092A10 CRANKSHAFT PULLEY - R + R     Op. 1092G14 ENGINE COMPONENT SINGLE BELT MOVING TENSIONER - R + R     Op. 1032A12 TIMING SYSTEM DRIVE CHAIN - R.R 1. Remove the timing drive pulley.2. Undo the bolt (2a) and remove the timing chain (2b) lubrication jet. Refitting ( Removing ) 1. Position the timing chain lubrication jet (1a) in its housing and secure it tightening the bolt (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Timing chain lubrication jet	Bolt	M	(engine block side) 1.0	1.9 JTS2.2 JTS

2. Place the timing drive pulley in its housing.     Op. 1032A12 TIMING SYSTEM DRIVE CHAIN - R.R     Op. 1092G14 ENGINE COMPONENT SINGLE BELT MOVING TENSIONER - R + R     Op. 1092A10 CRANKSHAFT PULLEY - R + R     Op. 1092G10 SINGLE ENGINE BELT - R.R     Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.     Op. 4450B04 RIGHT FRONT WHEEL - R.R     Op. 1048A28 VACUUM AIR CIRCUIT RESONATOR PIPE - R+R - Connect the negative battery terminal.    Op. 0010T71 POWER STEERING FLUID CHECK LEVEL AND TOP UP IF NECESSARY     Op. 0010T75 HYDRAULIC POWER STEERING SYSTEM BLEED AIR - Remove the vehicle from the lift.