939010529 - 1056F17 THROTTLE BODY WITH DVL R R

Removing ( Refitting ) - Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

    Op. 1048A34 SLEEVE(S) FROM FLOW METER TO AIR SUPPLY CAPACITY CASE - R + R 1. Disconnect the electrical connection from the throttle casing with D.V.L.

	Description	Connector
1	Integrated throttle casing actuator	See N075 THROTTLE BODY ACTUATOR

2. Undo the bolts (2a) and remove the throttle casing with D.V.L. (2b).- Remove the air chamber gasket. Refitting ( Removing ) - Place a new gasket in its housing on the air chamber.1. Place the throttle casing with D.V.L. (1a) in its housing and secure it tightening the bolts (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Throttle body built into DVL	Bolt	M6	(air chamber side) 0.9	1.9 JTS2.2 JTS

2. Connect the electrical connection to the throttle casing with D.V.L.     Op. 1048A34 SLEEVE(S) FROM FLOW METER TO AIR SUPPLY CAPACITY CASE - R + R - Connect the negative battery terminal.