939010624 - 1080B97 RIGHT REAR LAMBDA SENSOR ON CATALYTIC CONVERTER R R

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

1. Disconnect the electrical connection for the right rear Lambda sensor to the catalytic converter.

	Description	Connector
1	Lambda sensor on catalyzer 2	See K018 LAMBDA SENSOR ON CATALYZER - 2

- Release the electrical wiring for the right rear Lambda sensor to the catalytic converter from the clip on the heat shield.    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. 1. Using a suitable spanner, undo and remove the right rear Lambda sensor to the catalytic converter. Refitting ( Removing ) 1. Position the right rear lambda sensor in its housing on the catalytic converter and tighten it to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Right rear Lambda sensor to catalytic converter	-	M18	(exhaust manifold side with catalytic converter) 4.1 - 5.0	1.9 JTS2.2 JTS3.2 JTS

    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. - Fasten the electrical wiring for the right rear Lambda sensor to the catalytic converter with the clip on the heat shield.- Connect the electrical connection for the right rear Lambda sensor to the catalytic converter.- Connect the negative battery terminal.- Remove the vehicle from the lift.