939010712 - 1810A24 CLUTCH - R + R WITH GEARBOX REMOVED

Removing ( Refitting ) 1. Fit the flywheel lock.
ToolDescriptionFunctionValidity
1860846000Counter-torqueFlywheel lock
2. Unscrew the three bolts spaced at 120° securing the clutch cradle.3. Fit the locating pin (3a) and the remaining part of tool (3b), tightening bolts (3c) into the sockets of the bolts removed previously.
ToolDescriptionFunctionValidity
1871003100Extractor/ Fitting toolClutch mechanism removal1.9 JTS2.2 JTS
4. Turn the tool handwheel until pins (4a) are in contact with disc (4b).5. Undo the remaining bolts securing the clutch cradle.6. Undo the tool handwheel to discharge the clutch mechanism diaphragm spring.- Remove the tool.
ToolDescriptionFunctionValidity
1871003100Extractor/ Fitting toolClutch mechanism removal1.9 JTS2.2 JTS
7. Remove the clutch tray.- Remove the clutch plate.
Refitting ( Removing ) 1. Fit the tool locating pin into the crankshaft.2. Refit the clutch mechanism in position.
It is not possible to replace the cltuch plate on its own. Instead the clutch plate/cradle assembly must be replaced.
When fitting the clutch plate the correct position is shown by the words "engine side" and "gearbox side".
Handle the clutch plate carefully. Do not touch the surfaces of the friction linings with your hands.
Clean any anti-corrosion protection or detergents from the friction surface of the clutch tray.
3. Fit the remaining part of tool (3a) for fitting the clutch device and tighten bolts (3b).4. Turn the tool handwheel until pins (4a) are in contact with disc (4b).5. Hand tighten the three free retaining bolts until the clutch device is packed together.6. Undo the tool handwheel to discharge the clutch mechanism diaphragm spring.- Remove the tool.
ToolDescriptionFunctionValidity
1871003100Extractor/ Fitting toolClutch mechanism removal1.9 JTS2.2 JTS
- Tighten the remaining clutch fixing bolts by hand.- Gradually tighten the bolts fixing the clutch diagonally until the recommended torque is reached.
ComponentFasteningdia  Value (daNm)Validity
Clutch drip trayBolt (pretreated to be replaced)M8(engine flywheel side) 2.3 - 2.8
7. Remove the flywheel lock.
ToolDescriptionFunctionValidity
1860846000Counter-torqueFlywheel lock