939005316 - 2720D10 SEMISHAFT WITH LEFT OR RIGHT JOINT (ONE) - R.R.

Removing ( Refitting )     Op. 4450B13 REAR WHEELS (TWO) - R.R 1. Unscrew the plug and drain the rear differential fluid into a special container. 1. Loosen the collar fastening the front silencer to the catalyzer assembly. - Disconnect the front exhaust silencer from the flexible support mounting.- Disconnect the two rear silencers from the flexible mountings.- Remove the exhaust silencer assembly.1. Remove the two stakings and undo the nut (1a) securing the driveshaft to the wheel hub using the tool (1b) for counter-torque.

Tool	Description	Function	Validity
1870815000	Counter-torque	Loosen/ tighten nut securing driveshaft to wheel hub

1. Disconnect the handbrake cable from the brake caliper.2. Undo the bolts (2a) fixing the brake caliper bracket (2b) to the stub axle.- Move the brake caliper and bracket assembly to one side and secure it. 1. Undo the upper bolt fixing the stub axle to the rear suspension upper transverse arm. 1. Loosen the bolt (1a) and undo the bolt (1b) fixing the lower stub axle (1c) to the longitudinal arm.2. Undo the bolt fixing the shock absorber to the longitudinal arm. 1. Undo the bolt (1a) securing the ABS wheel rpm sensor (1b) to the stub axle. - Release the driveshaft from the differential and remove it from the stub axle. Refitting ( Removing ) - Place the driveshaft complete with joints in position.- Position the ABS rpm sensor in its housing and secure it using the bolt.- Connect the shock absorber to the longitudinal arm and screw in the fixing bolt without tightening it to torque.- Connect the stub axle to the longitudinal arm and screw in the fixing bolts without tightening them to torque.- Connect the stub axle to the upper transverse arm and screw in the fixing bolt without tightening it to torque.- Place the brake caliper bracket back in its housing and secure it to the stub axle using the bolt.- Connect the handbrake cable to the brake caliper.- Tighten the new nut securing the driveshaft to the wheel hub to the recommended torque using the tool used for the removal for counter-torque.

Component	Fastening	dia	Value (daNm)	Validity
Rear wheel hub	Nut	M24	see operation 4450D10	3.2 JTS

- Stake the nut collar twice.- Place the exhaust silencer assembly in its housing and connect it to the flexible supports.- Tighten the mounting collar to the catalyzer assembly.    Op. 0010T54 REAR DIFFERENTIAL FLUID - REPLACE    Op. 4450B13 REAR WHEELS (TWO) - R.R - With the vehicle positioned on a lift and in "standard 0" or "standard A" static load conditions, tighten the following fastenings to torque.

Component	Fastening	dia	Value (daNm)	Validity
Longitudinal arm side shock absorber	Bolt	M14	13.0 ÷ 16.0

Component	Fastening	dia	Value (daNm)	Validity
Steering knuckle side longitudinal arm	Bolt (to be replaced)	M14	9.9 ÷ 12.1 + 90°

- Complete the fittingof the stub axle with the respective toe in and camber adjustment bolts as described in the specific "wheel geometry" procedure.- Refer to    Op. 4450A40 REAR WHEEL GEOMETRY - CHECK USING OPTICAL EQUIPMENT, INCLUDES ADJUSTMENT IF NECESSARY