939005321 - 3340B40 RIGID PIPE from hydraulic control unit to intermediate connector for right front brake - R.R.

Removing ( Refitting )     Op. 5530B10 BATTERY - R+R     Op. 1072B50 AIR CHAMBER - R.R.

The rigid pipe is connected to the ABS hydraulic control unit in the threaded opening marked "VR".

1. Undo the fixing nuts and move the engine coolant reservoir to one side. - Unscrew the brake-clutch fluid reservoir plug and fit the tool.

Tool	Description	Function	Validity
2000001400	Plug	Brake/ clutch system vacuum

1. Undo the intermediate connector for the rigid pipe.- Release the rigid pipe from the retaining clips. 1. Disconnect the electrical connection for the brake-clutch minimum level sensor.

	Description	Connector
	Brake fluid level sensor (switch)	See K025 BRAKE FLUID LEVEL SENSOR (SWITCH)

2. Disconnect the electrical connection for the ABS control unit.

	Description	Connector
2	ABS control unit	See M050 ABS CONTROL UNIT

3. Undo the connector fixing the rigid pipe to the ABS control unit.- Release the rigid pipe from the retaining clips and remove it. Refitting ( Removing ) - Place the rigid pipe in position and fasten it to the retaining clips.- Connect the electrical connections to the ABS control unit and to the brake-clutch fluid minimum level sensor.- Tighten the right front brake rigid pipe intermediate connector.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10/M12	1.4 ÷ 1.8

- Tighten the connector fixing the rigid pipe to the ABS control unit.

Component	Fastening	dia	Value (daNm)	Validity
Brake pipe connectors	Connector	M10/M12	1.4 ÷ 1.8

- Place the engine coolant reservoir in its housing.    Op. 1072B50 AIR CHAMBER - R.R.    Op. 5530B10 BATTERY - R+R     Op. 0010T65 HYDRAULIC BRAKE SYSTEM - BLEED AIR