939003555 - A002 ALARM AND CENTRAL LOCKING NOT ACTIVATED

The alarm system comes on automatically the moment the doors are locked using the key remote control. Ошибка в шаблоне. В ближайшее время мы ее исправим. (Error in Templaite)
Results of the tests
0PRELIMINARY CHECKSAll OKProblems encounteredOperation
Check that:. The doors lock mechanically using the insert that comes with the vehicle. The key remote controls are both working and transmit the RF codes. The time that the key remote control buttons is pressed is correct and that they have not been pressed too many timesMove on to Step 1The doors do not lock using the insertProceed as instructed in the    See table P010 CENTRAL LOCKING NOT WORKING
One remote control is not working on account of a failureReplace the remote control and programme the keys    Op. 5580E ANTI-THEFT DEVICE
Both remote controls are not workingThere is a lack of synchronism with the variable code: restore the code synchronism by carrying out the    See Test 5580EA ANTI-THEFT REMOTE CONTROL OPERATION CHECK
The transmitter battery has been changed but it is not workingThere is a lack of synchronism with the variable code: restore the code synchronism by carrying out the    See Test 5580EA ANTI-THEFT REMOTE CONTROL OPERATION CHECK
The remote controls do not work in certain places where there is strong electro-magnetic interferenceIt is not possible to carry out any type of operation. Carry out the test somewhere far away from anti-theft transmitters, hospitals, electric power stations, industrial zone, radio-television transmitters
The buttons in the remote control have been pressed for too long or the remote control button has been pressed too many timesThe NBC system has gone into protective mode. Wait 30 seconds without pressing the buttons and try again
1CHECKS USING DIAGNOSTIC EQUIPMENTAll OKProblems encounteredOperation
Connect the diagnotsic equipment to the diagnostic socket.Check at the Body Computer node that the logistic mode is not activatedMove on to Step 2Logistic mode activatedDeactivate the logistic mode
2CHECK USING DIAGNOSTIC EQUIPMENTAll OKProblems encounteredOperation
Check:. There are no faults at the TEG-Reader node. The presence of the alarm system at the CAN. There are no control unit errors at the Body Computer. The programming state of the remote controlsMove on to Step 3Remote control battery run downCheck the voltage of the remote control battery by carrying out the    See Test 5580EA ANTI-THEFT REMOTE CONTROL OPERATION CHECKand, if run down, replace it
Remote controls not working as they are not programmedCarry out the remote control programming procedure    Op. 5580E ANTI-THEFT DEVICE
Remote controls used do not conformReplace the remote controls checking their conformity and programme them    Op. 5580E ANTI-THEFT DEVICE
3CHECK ON CORRECT OPERATIONAll OKProblems encounteredOperation
Check that the fault is no longer presentEnd of diagnosisFault persistsReplace the key recognition device    Op. 5505A31 ELECTRONIC KEY ACKNOWLEDGEMENT DEVICE - R. R.