939010368 - 0010T12 ENGINE OIL AND FILTER - REPLACE

Engine oil is harmful to skin: keep contact with skin to a minimum and if there is contact wash with soap and water.
    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. - With the engine hot, remove the filler cap and release the engine oil dipstick.1. Remove the oil filter cover (1a) and the seal (1b).2. Extract the engine oil filter cartridge.
1. Undo the drain plug in the crankcase sump and leave the oil to drain into a suitable container.2. Clean the drain plug and replace the O-ring.
Be very careful when removing the drain plug, the oil could be very hot.
Do not let the oil disperse into the environment as indiscriminate dispersion of this product causes pollution.
- Tighten the oil drain plug to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Engine oil drain plug--1.41.8
- Place a new engine oil filter cartridge in its housing.- Fit an engine oil filter cover complete with new gasket and tighten it to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Engine oil filter cover--2.5
- Refill the engine lubrication circuit with the recommended oil.
The table shows the quantity for periodic replacement.
- Check that the engine oil level is correct using the dipstick.
The oil level is checked with the vehicle on a flat surface.
- Fit the filler cap, let the engine idle for about 2 minutes, switch off the engine and then wait for several minutes.- Check the oil level and make sure there are no leaks.    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.