4110A30 SUPPORT WITH STEERING CONTROL SHAFTS - R+R - Alfa - 159 - eLearn

939010816 - 4110A30 SUPPORT WITH STEERING CONTROL SHAFTS - R+R

)

Follow all the recommended safety instructions.

Op. 5580C18 AIR BAG MODULE - R+R Op. 4110A10 STEERING WHEEL - R+R FOR REPLACEMENT OR CHECKS Op. 5580C23 DRIVE SIDE KNEE PROTECTION AIR BAG MODULE R. R. Op. 7040A37 FUSE BOX COVER IN INSTRUMENT PANEL - R.R Op. 5505A43 CONTROL UNIT (DIGITAL NETWORK NODE) IN DRIVER'S DOOR - R.R. WITH PANEL REMOVED 1. Undo the fixing bolt (1a) and disconnect the steering column (1b) from the steering box.

The bolt is the pre-treated type and it therefore cannot be reused when refitting.

Prevent the steering column from turning under all circumstancdes until the steering column has been refitted to the steering box. Ensure the steering box is located centrally.

1. Unscrew the lower bolt securing the mount with the steering control shafts to the facia.

1. Unscrew the two upper bolts securing the mount with the steering control shafts to the facia.

1. Disconnect the electrical connection from the steering lock node.

	Description	Connector
1	Steering lock control unit (NBS)	See M089 STEERING LOCK CONTROL UNIT (NBS)

1. Remove the support and steering shaft assembly.

Refitting ( Removing

) - Refit the support and steering shaft assembly.- Connect the electrical connection to the steering lock node.1. Tighten the two upper bolts securing the mount with the steering control shafts to the facia to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Support with steering control shafts.	Bolt	M8	(dashboard crossmember side) 2.2 - 2.6

1. Tighten the lower bolt securing the mount with the steering control shafts to the facia to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Support with steering control shafts.	Bolt	M8	(dashboard crossmember side) 2.2 - 2.6

1. Connect steering column (1a) to the power steering box pinion and secure by tightening a new bolt (1b) to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Steering column	Bolt (pretreated to be replaced)	M8	(power assisted steering box side) 2.3 - 2.8

The steering shaft must be positioned in the correct position in relation to the pinion.

If a new mount with steering shafts is fitted, remove the device to prevent the steering column from turning.

Op. 5505A43 CONTROL UNIT (DIGITAL NETWORK NODE) IN DRIVER'S DOOR - R.R. WITH PANEL REMOVED Op. 7040A37 FUSE BOX COVER IN INSTRUMENT PANEL - R.R Op. 5580C23 DRIVE SIDE KNEE PROTECTION AIR BAG MODULE R. R. Op. 4110A10 STEERING WHEEL - R+R FOR REPLACEMENT OR CHECKS Op. 5580C18 AIR BAG MODULE - R+R