939004833 - 7030B50 SUN ROOF SLIDING GUIDE (ONE), LH OR RH - R.R
Removing
(
Refitting
)
For the left and right sides Op. 7040H30 FRONT PILLAR TRIM (ONE), LEFT OR RIGHT - R.R. Op. 7040L40 FRONT DOOR RUNNING BOARD (ONE), LEFT OR RIGHT - R.R. For the left and right sides Op. 7040L44 REAR DOOR RUNNING BOARD (ONE), LEFT OR RIGHT - R.R. Op. 7040H36 CENTRE PILLAR LOWER ELEMENT (ONE), LEFT OR RIGHT - R.R For the left and right sides Op. 7040H38 CENTRE PILLAR UPPER ELEMENT (ONE), LEFT OR RIGHT - R.R Op. 7050A20 ONE-PIECE REAR SEAT CUSHION - R.R. Op. 7050A19 REAR SEAT BACKREST - R.R For the left and right sides. Op. 7040H42 REAR PILLAR TRIM (ONE), LEFT OR RIGHT- R.R Op. 7040E40 MODULAR FRONT COURTESY LIGHT - R R Op. 7030B70 SUN ROOF MOVEMENT MOTOR - R+R Op. 7030B34 SLIDING ROOF COMPARTMENT DECORATIVE SEAL - R+R Op. 7040E15 SIDE COURTESY LIGHT (ONE) - R.R. ON VERSIONS WITH SUN ROOFFor the left and right sides. Op. 7065C34 SUN BLIND (ONE), LEFT OR RIGHT - R.R. Remove all the handles. Op. 7065C30 GRAB HANDLE (ONE) LEFT, RIGHT OR CENTRE PASSENGER COMPARTMENT INTERIOR - R.R For the left and right sides. Op. 7045A10 FRONT SEAT (ONE), LEFT OR RIGHT - R.R. For the left side. Op. 7010A34 REAR SIDE DOOR COMPARTMENT SEAL - R.R Op. 7040L71 BOX ON TUNNEL REAR COATING - R R Op. 5010C32 AIR VENT ON TUNNEL COVER FOR REAR SEATS - R.R. Op. 7040L37 GEAR LEVER TRIM - R.R Op. 3380A44 HANDBRAKE/LINKAGE PROTECTION - R+R Op. 7040L20 TUNNEL COVER - R.R Op. 7040L23 TRIM ON TUNNEL COVER - R.R.For the left and right sides Op. 7040A65 CONSOLE SIDE CLOSING (ONE) - R.R. Op. 7040L74 TUNNEL TRIM SUPPORT BRACKET/MOUNT R R Op. 7040H16 ROOF PANEL LINING FOR VERSIONS WITH SUN ROOF - R.R Op. 7030B10 SLIDING ROOF (ASSEMBLY) - R+R WITH ROOF PANEL REMOVED Op. 7030B40 DRAINAGE CHANNEL - R R1. Slide the slide (1a) manually backwards into its channel until it can be extracted. | Whilst sliding the slide, firstly the pin (1b) and then the slit (1c) should be either inside or outside of the rail (1d) as shown in the diagram. |
Refitting
(
Removing
)
- Check that the slide is not damaged.- If removed, insert the slide and drive cable in the main slide.1. Slide the slide (1a) manually forwards into its sliding rail until it can be extracted. | Whilst sliding the slide, firstly the pin (1b) and then the slit (1c) should be either inside or outside of the rail (1d) as shown in the diagram. |
