939004852 - 7210A32 R.R. PARTIAL FRONT SHOCK ABSORER TURRET MOUNTING (ONE), LEFT OR RIGHT

Removing ( Refitting )     Op. 7210E20 R.R. BONNET     Op. 7210A15 R.R. FRONT WING/HEADLAMP HOUSING CROSSMEMBER    Op. 7210A18 R.R FRONT CROSSMEMBER     Op. 7210E18 R.R. FRONT WING     Op. 7210A46 R R (COMPLETE) UPPER FRONT STRUT (ONE) LH OR RH- Check that the components connected are not distorted by checking the bodyshell alignment measurements using suitable equipment (gauges, templates or jigs).- Straighten the body as necessary. 1. Use the hack saw following the cutting line in the diagram.2. Grind the seam weld shown in the figure. - Use a rotary brush to remove the paint to gain access to the spot welds.1. Use the chamfering machine to remove the spot welds shown in the diagram.- Use the drill and chamfer the spot welds not accessible with the chamfering machine.- Use the hammer and chisel and remove the spot welds chamfered previously.- Remove the part and the offcuts from the vehicle. - Straighten the edges of the vehicle using a hammer and dolly block.- Remove the spot weld residues using a disc grinder.- Use a rotary brush to clean the areas treated previously.1. Apply electro-galvanizing paint. Refitting ( Removing ) 1. Remove the anti-corrosion treatment from the entire perimeter of the inside and outside of the replacement part using a rotary brush.2. Drill out part at the points indicated.- Apply electro-weldable paint to the edges involved. 1. Position the replacement part correctly on the vehicle and secure it using self-locking clamps.- Check the alignment and the surrounding gaps.2. Use a spot welder in the areas shown in the diagram.3. Use a MIG welder and fill weld the openings made previously. 1. Use a MIG welder to seam weld in the join areas. - Correct any distortions to the panel using a mallet and dolly block.1. Use a disc grinder to level the welds.- Use a rotary brush to clean the areas welded previously. 1. Apply anti-oxidant protection to the areas involved in the welding.- Seal the join lines between the replacement part and the vehicle.     Op. 7210A46 R R (COMPLETE) UPPER FRONT STRUT (ONE) LH OR RH    Op. 7210E18 R.R. FRONT WING     Op. 7210A18 R.R FRONT CROSSMEMBER     Op. 7210A15 R.R. FRONT WING/HEADLAMP HOUSING CROSSMEMBER    Op. 7210E20 R.R. BONNET