| 0 | PRELIMINARY CHECKS | ALL OK | PROBLEMS ENCOUNTERED | ACTION | 
|---|
|  | "Rock" in the seat resting against the backrest; check the fastenings to the floor (two M8 bolts) releasing the tension and check the front mountings. | Move on to Step 1 | Creaking; non alignment of guides during sliding stage (twist effect). | Retighten the seat to the floor following the correct guide alignment cycle. | 
| 1 | CHECK ON FAULTY CONTACTS AT GUIDE BAYONETS | ALL OK | PROBLEMS ENCOUNTERED | ACTION | 
|---|
|  | Remove the seat from the floor and check for possible irregular contacts at the guide bayonets (front). | Move on to Step 2 | Noise disappears | Check the plastic inserts on the floor and lubricate the bayonet area with grease. | 
| 2 | CHECK ON GUIDE FASTENINGS TO SEAT | ALL OK | PROBLEMS ENCOUNTERED | ACTION | 
|---|
|  | Check the fastenings of the guides to the seat (6 M8 bolts) if the noise disappears. | Move on to Step 3 | Noise disappears | Retighten the seat to the floor following the correct tightening cycle. | 
| 3 | SEAT LIFTING HINGES CHECK | ALL OK | PROBLEMS ENCOUNTERED | ACTION | 
|---|
|  | Check for clearance at the seat lifting hinges and for noise at the torsion spring. | Move on to Step 4 | 1. Excessive clearance in the seat lifting hinges. | 1. Replace the seat lifting assembly    Op. 7045A36  DRIVER'S SEAT MANUAL HEIGHT ADJUSTMENT DEVICE - R.R | 
| 2. Noise from torsion spring. | 2. Lubricate the torsion spring and check the condition of the bush. | 
| 4 | BRACKET CONTACT CHECKS | ALL OK | PROBLEMS ENCOUNTERED | ACTION | 
|---|
|  | Check for the presence of contacts or detachment of the bracket. | Move on to Step 5 | 1. Contact with cushion components | 1. Move the bracket away from possible contact with the cushion. | 
| 2. Detachment of the bracket | 2. Replacement of connector holder bracket. | 
| 5 | PULLMAFLEX FASTENINGS CHECK | ALL OK | PROBLEMS ENCOUNTERED | ACTION | 
|---|
|  | Check for possible detachment of the pullmaflex fastenings on the frame or possible breaks. | End of diagnosis | Pullmaflex released, pullmaflex fastening tabs open or broken. | Reattach pullmaflex and tighten fastening tabs or replace pullmaflex. |