939010588 - 1072B10 INLET MANIFOLD - R + R AND REPLACE SEAL

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).    Op. 4450B04 RIGHT FRONT WHEEL - R.R     Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.     Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R.     Op. 1092G10 SINGLE ENGINE BELT - R.R     Op. 1092A10 CRANKSHAFT PULLEY - R + R     Op. 1016A10 SOUND-PROOFING COVER - R.R     Op. 1048A10 AIR FILTER ASSEMBLY - R.R.     Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.     Op. 1008B10 POWER UNIT FRONT SUPPORT FLEXIBLE MOUNTING (TIMING SIDE) - REPLACE     Op. 1032D12 TIMING SYSTEM PROTECTIVE COVER(S) - R + R     Op. 1092G20 ENGINE COMPONENT SINGLE BELT FIXED TENSIONER - ONE - R + R     Op. 1008A46 POWER UNIT RIGID SUPPORT - TIMING SIDE - R.R.     Op. 1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT     Op. 5530B10 BATTERY - R+R     Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R Op. 1048B27     Op. 1060G50 THROTTLE BODY - R.R     Op. 1080C24 E.G.R. SYSTEM SOLENOID - R + R     Op. 1060F36 PIPES (ALL) FROM FUEL MANIFOLD TO INJECTOR - R.R.     Op. 1060F20 PIPE FROM PRESSURE PUMP TO FUEL MANIFOLD - R.R.     Op. 1060F30 SINGLE FUEL MANIFOLD PIPE - R.R.     Op. 1048B22 AIR SUPPLY HOSE FROM HEAT EXCHANGER TO INTAKE MANIFOLD - R + R    Op. 1080C80 EXHAUST GAS/WATER HEAT EXCHANGER FOR EGR SYSTEM - R.R     Op. 1060F50 FUEL RETURN MANIFOLD - R.R.    Op. 1080D34 ENGINE OIL VAPOUR SEPARATOR - R + R - Disconnect the electrical connections from the heater plugs and move the electrical wiring sideways.

	Description	Connector
-	Heater plugs	See A040 HEATER PLUGS

- Disconnect the electrical connection for the pressure relief sensor.

	Description	Connector
-	Supercharging sensor	See K082 SUPERCHARGING SENSOR

- Disconnect the electrical connection from the fuel pressure regulator on the pressure pump.

	Description	Connector
-	Fuel pressure regulator	See N077 FUEL PRESSURE REGULATOR

- Disconnect the fuel supply pipe rapid connector, pressure pump side.1. Undo the bolts (1a) and move the alternator (1b) aside.

Take care over the positioning of the electrical wiring.

1. Undo the bolts (1a), (1b) and remove the pressure pump mounting (1c) complete with the pressure pump (1d). 1. Undo the nuts (1a) and remove the intake manifold (1b).- Remove the gasket. Refitting ( Removing ) - Place the gasket back in its housing.1. Place the intake manifold (1a) in its housing and secure it by tightening the nuts (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Intake manifold	Nut	M8	(cylinder head side) 2.3 - 2.8	1.9 JTD 8v

1. Fit the pressure pump mounting (1a) complete with pressure pump (1b) back in its housing and secure it tightening the bolts (1c) and (1d) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Pressure pump mounting	Bolt (pretreated to be replaced)	M8	(engine crankcase side) 2.3 - 2.8	1.9 JTD 8v

Component	Fastening	dia	Value (daNm)	Validity
Pressure pump mounting	Bolt	M10	(cylinder head side) 4.5 - 5.5	1.9 JTD 8v

1. Place the alternator (1a) in its housing and fasten it tightening the bolts (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
ALTERNATOR TO BRACKET	Bolt	M12	6,3 ÷ 7,6	1.9 jtd 16v1.9 jtd 8v2.4 jtd 20v

Component	Fastening	dia	Value (daNm)	Validity
ALTERNATOR TO IE PUMP MOUNTING	Bolt	M12	6,3 ÷ 7,6	1.9 jtd 16v1.9 jtd 8v

- Connect the fuel supply pipe rapid connector, pressure pump side.- Connect the electrical connection to the fuel pressure regulator on the pressure pump.- Connect the electrical connection for the pressure relief sensor.- Refit the electrical wiring and connect the electrical connections to the heater plugs.    Op. 1080D34 ENGINE OIL VAPOUR SEPARATOR - R + R     Op. 1060F50 FUEL RETURN MANIFOLD - R.R.    Op. 1080C80 EXHAUST GAS/WATER HEAT EXCHANGER FOR EGR SYSTEM - R.R     Op. 1048B22 AIR SUPPLY HOSE FROM HEAT EXCHANGER TO INTAKE MANIFOLD - R + R    Op. 1060F30 SINGLE FUEL MANIFOLD PIPE - R.R.     Op. 1060F20 PIPE FROM PRESSURE PUMP TO FUEL MANIFOLD - R.R.     Op. 1060F36 PIPES (ALL) FROM FUEL MANIFOLD TO INJECTOR - R.R.     Op. 1080C24 E.G.R. SYSTEM SOLENOID - R + R     Op. 1060G50 THROTTLE BODY - R.R Op. 1048B27     Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R     Op. 5530B10 BATTERY - R+R     Op. 1032B10 TOOTHED TIMING BELT - R + R FOR TIMING ADJUSTMENT OR REPLACEMENT     Op. 1008A46 POWER UNIT RIGID SUPPORT - TIMING SIDE - R.R.     Op. 1092G20 ENGINE COMPONENT SINGLE BELT FIXED TENSIONER - ONE - R + R     Op. 1032D12 TIMING SYSTEM PROTECTIVE COVER(S) - R + R     Op. 1008B10 POWER UNIT FRONT SUPPORT FLEXIBLE MOUNTING (TIMING SIDE) - REPLACE     Op. 1048A10 AIR FILTER ASSEMBLY - R.R.     Op. 1092A10 CRANKSHAFT PULLEY - R + R     Op. 1092G10 SINGLE ENGINE BELT - R.R     Op. 7055B91 RIGHT FRONT WHEEL ARCH LINER - R.R.     Op. 7055B66 ENGINE COMPARTMENT DUST COVER IN RIGHT FRONT WHEEL ARCH - R.R.     Op. 4450B04 RIGHT FRONT WHEEL - R.R     Op. 0010T20 ENGINE COOLANT - CHANGE     Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.     Op. 1016A10 SOUND-PROOFING COVER - R.R - Connect the negative battery terminal.- Remove the vehicle from the lift.