939010622 - 1080B64 CATALYTIC CONVERTER EXCESS TEMPERATURE THERMOCOUPLE - R + R

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

1. Disconnect the electrical connection of the catalytic converter excessive temperature signal thermocouple.

	Description	Connector
1	Upstream particulate filter temperature sensor (DPF)	See K189 UPSTREAM PARTICULATE FILTER TEMPERATURE SENSOR (DPF)

    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. 2. Unscrew and remove the catalytic converter excessive temperature signal thermocouple. Refitting ( Removing ) - Position the catalytic converter excessive temperature signal thermocouple in its housing and tighten it to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Thermal coupling signalling catalytic converter overheating	-	M14	(catalytic converter side) 4.5	1.9 JTD 8V1.9 JTD 16V2.4 JTD 20V

    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. - Connect the electrical connection of the catalytic converter excessive temperature signal thermocouple.- Connect the negative battery terminal.- Remove the vehicle from the lift.