939010660 - 1084C10 ENGINE OIL HEAT EXCHANGER - R + R

Removing ( Refitting ) - Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).
DescriptionConnector
-Battery    See A001 BATTERY
    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. 1. Undo the radiator coolant drain plug.
Collect the coolant in a suitable container.
1. Disconnect the electrical connection from the engine oil level sensor.
DescriptionConnector
1Engine oil level sensor    See K032 ENGINE OIL LEVEL SENSOR
2. Loosen the bands and disconnect the engine coolant inlet and outlet pipes from the engine oil heat exchanger.3. Undo the bolts (3a) and remove the engine oil heat exchanger as necessary to disconnect the electrical connection from the engine oil pressure switch (3b).
DescriptionConnector
3bInsufficient engine oil pressure sensor (switch)    See K030 LOW ENGINE OIL PRESSURE SENSOR (SWITCH)
1. Remove the engine oil heat exchanger.2. Remove the heat exchanger and engine oil filter mounting (2a), complete with gaskets (2b).3. Working at the bench, place the heat exchanger and engine oil filter mounting in a vice then, using the tool (3a), undo and remove the engine oil filter cover (3b) complete with O-Ring seals (3c).
ToolDescriptionFunctionValidity
2000003900SpannerLoosen/ tighten engine oil filter cover1.9 JTD 8V1.9 JTD 16V
4. Remove the engine oil cartridge filter.
Refitting ( Removing ) - Place the engine oil filter cartridge in its housing.- Place the engine oil filter cover complete with a new O-rings in its housing and tighten it using the tool.
ToolDescriptionFunctionValidity
2000003900SpannerLoosen/ tighten engine oil filter cover1.9 JTD 8V1.9 JTD 16V
- Place the heat exchanger and engine oil filter mounting in position complete with new gaskets.- Connect the electrical connection to the engine oil pressure switch then place the engine oil heat exchanger in position and tighten the bolts to the recommended torque.
ComponentFasteningdia  Value (daNm)Validity
Engine oil heat exchangerBoltM10(support side) 4.5 - 5.51.9 JTD 8V1.9 JTD 16V
- Connect the engine coolant inlet and outlet pipes to the engine oil heat exchanger and tighten the bands.- Connect the electrical connection to the engine oil level sensor.- Tighten the coolant drain plug to the radiator.- Connect the negative battery terminal.    Op. 0010T20 ENGINE COOLANT - CHANGE     Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R. - Remove the vehicle from the lift.