939010761 - 3310A57 FRONT BRAKE CALIPER BRACKET (ONE), LEFT OR RIGHT - R.R

Removing ( Refitting )

The following procedure describes left front brake caliper bracket removal/refitting, do the same for the right front brake caliper bracket.

- Position the vehicle on a lift.- Make sure that the ignition key is in the OFF position, then disconnect the battery terminal (-).

	Description	Connector
-	Battery	See A001 BATTERY

    Op. 4450B02 LEFT FRONT WHEEL - R.R 1. Disconnect the electrical connection for the brake pad wear sensor and release the wiring from the fastenings.

	Description	Connector
1	Left brake pad wear sensor (switch)	See K020 LEFT BRAKE PAD WEAR SENSOR (SWITCH)

There is no brake pad wear sensor on the right front caliper.

1. Remove the brake caliper traction spring. 1. Remove the plugs (1a) and undo the brake caliper fixing bolts (1b). - Move the brake caliper out of its housing without disconnect the flexible pipe and secure it appropriately.1. Undo the bolts (1a) and remove the front brake caliper bracket (1b). Refitting ( Removing ) 1. Position the front brake calliper bracket (1a) in its housing and secure it tightening the bolts (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Front brake caliper brackets	Bolt	M14	(steering knuckle side) 19.0 - 27.0	1.81.9 JTS2.2 JTS3.2 JTS1.9 JTD 8V1.9 JTD 16V

- Place the brake caliper in its housing.1. Tighten the bolts (1a) fixing the brake caliper to the recommended torque and fit the plugs (1b).

Component	Fastening	dia	Value (daNm)	Validity
Front brake calipers	Bolt	M8	(bracket side) 2.5 - 3.0	1.81.9 JTS2.2 JTS3.2 JTS1.9 JTD 8V1.9 JTD 16V

- Refit the brake caliper traction spring in its seat.- Connect the electrical connection for the brake pad wear sensor and fasten the electrical wiring.    Op. 4450B02 LEFT FRONT WHEEL - R.R - Connect the negative battery terminal.- Remove the vehicle from the lift.