939010866 - 4450D14 STUB AXLE FOR ONE REAR WHEEL HUB, LEFT OR RIGHT - R.R WITH HUB REMOVED - INCLUDES BUSH REPLACEMENT IF NECESSARY - CHECK WHEEL GEOMETRY SEPARATELY

Removing ( Refitting )

The following procedure describes the removing-refitting of the right rear wheel stub axle, carry out the same operations for the left rear wheel stub axle.

1. Undo the bolts (1a) and remove the rear brake disc guard (1b). 1. Unscrew bolt (1a) and remove the rear wheel rpm sensor (1b) from the steering knuckle. - Position a hydraulic jack underneath the rear wheel stub axle.1. Undo the bolt fixing the rear suspension front wishbone, stub axle side.2. Unscrew bolt (2a) and bolt (2b) securing the rear wheel hub stub axle, rear suspension longitudinal arm side.3. Remove the rear wheel hub stub axle. Refitting ( Removing ) 1. Place the rear wheel hub stub axle back in its housing.2. Tighten bolt (2a) and bolt (2b) securing the rear wheel hub stub axle, rear suspension longitudinal arm side, to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Steering knuckle side longitudinal arm	Bolt (to be replaced)	M14	9.9 ÷ 12.1 + 90°

Component	Fastening	dia	Value (daNm)	Validity
Steering knuckle side longitudinal arm (toe in)	Bolt	M14	9.5 ÷ 10.5 + 45°

3. Tighten the bolt fixing the rear suspension front wishbone, stub axle side, to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Steering knuckel side camber rod	Bolt	M12	7.8 ÷ 9.3 + 30°

- Remove the hydraulic jack underneath the rear wheel stub axle. 1. Position the rear wheel rpm sensor (1a) in its housing and secure it tightening the bolt (1b) to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Rear wheel rpm sensor	Bolt	M6	(steering knuckle side) 0.7 - 1.1

- Place the rear brake disc shield back in its housing and secure it using the bolts.