939011060 - INTRODUCTION - WARNING AND MANOUEVRING SIGNALS
WARNINGS
 | This vehicle is equipped with a starting system known as Smart-Key, whereby the traditional ignition key has been replaced with an electronic key "T.E.G.", (Transmitter for Entry and Go), combined with an electronic key reader and TEG-Reader radio frequency receiver. |
The vehicle is not switched on/started up by inserting the key in the ignition switch (which is no longer present) and turning it, but rather by inserting the TEG in the TEG Reader and activating the START/STOP button.Access to the vehicle through radiofrequency recognition of the remote control incorporated into the TEG is entirely the same as what takes place with the traditional remote control incorporated into the key fob.The distribution of the power supply to the vehicle (ignition-controlled INT, INT/A, AVV, etc.) is managed by the steering lock node and takes place in entirely the same way as for models equipped with a traditional key.The following documentation often still uses the expressions Key ON, Key OFF, ignition-operated power supply (INT) or key to MAR, key to STOP, key to AVV. These must be interpreted in accordance with the following summary table:| Key ON | TEG inserted in TEG Reader |
| Key OFF | TEG removed from TEG Reader |
| ignition controlled power supply (INT) | TEG inserted into TEG Reader |
| key on MAR | TEG inserted in TEG Reader |
| key on STOP | TEG removed from TEG Reader |
| key on AVV | TEG inserted and START/STOP button pressed |
To prevent serious damage to the electrical and electronic components, never try and start the engine with the battery earth lead slack.Never pull the leads or wiring using force because this would result in the cables being disconnected from the connectors or terminals.Disconnect all the control units and electronic devices when carrying out arc welding operations on the bodyshell.Before replacing a fuse, check that the circuit protected is not faulty.When replacing fuses, make sure that the new fuse is the correct amperage. - Do not use fuses that have a higher or lower amperage than required.PRECAUTIONS
When working on electrical components, always follow very carefully the precautions described below:
- Remove rings, wrist watches and other metal objects.
- Take care with electrical arcs: Even if the voltage is 12V, the battery can produce high currents if there is a short circuit, creating arcs or sparks that can be dangerous to the mechanic or create a fire hazard;
- Take care over high voltages. The electronic ignition system produces voltages of 20,000V and more, which could be very dangerous. Take great care when working on or near these components.
- Prevent fire risks. Do not smoke when working close to the battery or components which get hot during use (e.g. halogen bulbs), nor in the area of the engine compartment when the engine is still hot.
Before working on the electrical system (connectors, electrical components, wiring etc.), always DISCONNECT THE BATTERY. | If the battery is disconnected, the Steering Lock Node remains in the condition (unlocked or locked) that it is in: during workshop operations and repairs, whenever it is necessary to turn the steering wheel with the battery disconnected, leave the TEG inserted when the battery is disconnected. The steering will therefore remain released and free to turn. |