5580C44 FRONT SIDE BAG MODULE (ONE) LH OR RH - R.R - Alfa - 159 - eLearn

939011098 - 5580C44 FRONT SIDE BAG MODULE (ONE) LH OR RH - R.R

Removing ( Refitting

)

Before removing and refitting the Air Bag module the following preliminary operations must be carried out.

- Extract the electronic key.- Disconnect the battery leads and insulate them.- Wait for 10 minutes before continuing.

FOLLOW ALL THE RECOMMENDED SAFETY INSTRUCTIONS Op. 5580C AIR BAG SYSTEM

Op. 7045A10 FRONT SEAT (ONE), LEFT OR RIGHT - R.R. Op. 7045A25 FRONT SEAT BACKREST LUMBAR ADJUSTMENT KNOB (ONE), LEFT OR RIGHT - R.R. 1. Lower the trim and padding (1a) and release the panel of lumbar adjustment knob (1b) from retainers (1c).

1. Disconnect the backrest trim links.2. Release retainers (2a) from retainers (2b) along vertical sections (2c) and (2d).3. Disconnect retainer (3a) from crossmember (3b).4. Remove rear pane (4a) by releasing from upper retainers (4b).

1. Release retainer (1a) of the upper edge of the backrest trim from metal profile (1b).2. Press the disconnected edge in the upper part of the seat.3. Disconnect retainer (3a) by releasing links (3b).

1. Push the trim and padding slightly aside to gain access to the airbag module.2. Cut the wiring retaining bands.3. Disconnect the electrical connection.

Description	Component
DRIVER''S SIDE BAG	See Q030 DRIVER'S SIDE BAG
PASSENGER SIDE BAG	See Q031 PASSENGER SIDE BAG

4. Undo the nuts fixing the Air Bag module.5. Disconnect the electrical earth connection.6. Remove the Air Bag module.

- Place the Air Bag module in the special cupboard resting it on a free surface with the bag facing upwards.

Refitting ( Removing

) - Observe the following precaution.

Handle the Air Bag module very carefully. Make sure that the battery is disconnected.

- If a new module is being fitted, position the labels as described below.- Remove the detachable part of the adhesive label from the new module. Place a copy of the label in a special folder containing the vehicle details (model, registration date, chassis number) and the serial number of the old module. The file should be kept for future checks.Fit the detachable part of the original label on the lower part of the seat, where similar labels for the seat, the backrest cover and the Air Bag wiring can already be found. Beforehand, however, it should be perforated at the month and 14 years after the year in which the module is being fitted (e.g. 2005 for 2019).- Remove the Side Bag module.- Connect the electrical earth connection.- Tighten the nuts fixing the Air Bag module.

Component	Fastening	dia	Value (daNm)	Validity
SIDE AIR BAG MODULE	Nut	M5	0.4 ÷ 0.6

- Connect the electrical connection for the Air Bag module.- Fit the retaining bands on the wiring.- Position the trim with padding in its housing.- Tension the links and connect to the retainer.- Position the front edge of the backrest trim in its seat and connect to the metal profile.- Position the rear panel and do up the upper retainers.- Connect the retainer to the crossmember.- Connect the rear panel vertical retainers.- Connect the backrest trim links.- Attach the lumbar adjustment knob panel to the retainers. Op. 7045A25 FRONT SEAT BACKREST LUMBAR ADJUSTMENT KNOB (ONE), LEFT OR RIGHT - R.R. Op. 7045A10 FRONT SEAT (ONE), LEFT OR RIGHT - R.R. - Use an Examiner to check that the system has not acquired errors during the operation.