939011406 - 7210E72 R.R. FUEL FILLER BUSH WITH WING REMOVED

Removing ( Refitting ) - Check that the components connected are not distorted by checking the bodyshell alignment measurements using suitable equipment (gauges, templates or jigs).- Straighten the body as necessary. - Use a rotary brush to remove the paint to gain access to the spot welds.1. Use the drill and chamfer the spot welds shown in the diagram not accessible with the chamfering machine.- Use the hammer and chisel and remove the spot welds chamfered previously.2. Remove the part from the vehicle, cutting the sealant shown in the diagram. - Remove the spot weld residues using a disc grinder.- Use the rotary brush and remove the sealant residues on the vehicle.- Use a rotary brush to clean the areas treated previously.1. Apply electro-galvanizing paint. 1. Remove the anti-corrosion treatment from the entire perimeter of the inside and outside of the replacement part using a rotary brush.2. Drill the part at the points shown using the drill.3. Apply electro-weldable paint to the edges involved. Refitting ( Removing ) 1. Apply the sealant to the splining.2. Position the replacement part correctly on the vehicle and secure it using self-locking clamps.- Check the alignment and the surrounding gaps.3. Use a MIG welder and weld the openings made previously in the replacement part. 1. Use a disc grinder to level the welds.- Use a rotary brush to clean the areas welded previously. 1. Apply anti-oxidant protection to the areas involved in the welding.