1040B56 FUEL RETURN LINE - R R - Alfa - 156 - eLearn

3237674 - 1040B56 fuel return line - r r

) - 7050B18 rear seat arm rest - r+r Make sure that the ignition is off (STOP position), then disconnect the negative battery terminal (refer to op. 5530B10 battery - r+r ).

	Name	Connector
-	Battery	A1B

Position the vehicle on the lift.1. Undo the nuts (1a) and remove the access cover (1b) to the immersed pump assembly complete with gauge.2. Disconnect the electrical connection from the immersed pump assembly complete with gauge.

	Name	Connector
2	Fuel pump and sender unit	N40

3. Disconnect the coupling for the rear fuel return pipe from the tank.

Remove the handbrake boot.1. Lift up the handbrake lever (1a), loosen the adjustment nut (1b), then lower the lever.

Raise the car.Disconnect the handbrake cables (1a) from the mounting bracket (1b) and from the intermediate fixings (1c).

1. Position a hydraulic jack under the rear suspension crossmember.2. Undo the bolts (2a) and lower the rear suspension crossmember (2b), as necessary, using the hydraulic jack.

1. Position a hydraulic jack under the fuel tank.2. Undo the bolts (2a) and remove the fuel tank support belts (2b).3. Disconnect the intermdiate coupling for the rear fuel return pipe.

1. Lower the fuel tank as necessary to remove the rear fuel return pipe.

Refitting ( Removing

) Place the rear fuel return pipe back in its housing and fix it using the bands on the tank.Connect the intermdiate coupling for the rear fuel return pipe.Fit the tank support belts and fix them using the bolts.Remove the hydraulic jack from under the tank.Place the rear suspension crossmember in its housing using the hydraulic jack and fix it tightening the bolts to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Bolt	REAR CROSS-BEAM	M10	6.2 - 6.8

Remove the hydraulic jack from under the rear suspension crossmember.Connect the handbrake cables to the mounting bracket and to the intermediate fixings.Lower the vehicle. - 3380A04 handbrake - check travelRefit the handbrake boot.Connect the rear fuel return pipe coupling to the tank.Connect the electrical connection to the immersed pump assembly complete with gauge.Fit the access cover to the immersed pump assembly complete with gauge and fix it using the nuts.Remove the vehicle from the ramp.Connect the negative (-) battery terminal. - 7050B18 rear seat arm rest - r+r