| | Results of the tests |
| 0 | PRELIMINARY CHECKS | All OK | Problems met | Operation |
|---|
| Preliminarily
check the tyre inflation pressureVisually inspect the power assisted steering fluid level in the
reservoir |
Continue to Step
1
| Pressure not correct | Restore the tyre inflation
pressure |
| Power assisted steering fluid level too low | Restore the correct level, if there are leaks,
See
table
X30
|
| 1 | FRONT WHEEL GEOMETRY CHECK | All OK | Problems met | Operation |
|---|
|
Check
the front wheel geometry and angles,
Op. 4450A10 |
Continue to Step
2
| Geometry not correct |
Replace the suspesion springs
Op. 4410A10 |
| Angles not correct | Restore, where possible, the correct angles |
| 2 | CHECK REAR WHEEL GEOMETRY | All OK | Problems met | Operation |
|---|
|
Check
the rear wheel geometry and angles
Op. 4450A40 |
Continue to Step
3
| Geometry not correct |
Replace the suspesion springs
Op. 4420A10 |
| Angles not correct | Restore, where possible, the correct angles |
| 3 | STEERING COLUMN BEARINGS CHECK | All OK | Problems met | Operation |
|---|
| Check
the condition and the efficiency of the steering column support
bearings |
Continue to Step
4
| Bearings worn or damaged |
Replace the bearings involved
Op. 4110A34 |
| 4 | STEERING BOX CHECK | All OK | Problems met | Operation |
|---|
| Check
that the steering box is working properly: there should not be excessive
'power assistance' |
Continue to Step
5
| Steering box not properly
calibrated |
Replace the steering box
Op. 4130A10 |
| 5 | HECK ON CORRECT OPERATION | All OK | Problems met | Operation |
|---|
| Check
that the fault is no longer present | End of diagnosis | Fault persists | Search for the
fault starting from another symptom' |