4450D10 HUB OF ONE REAR WHEEL, L/H OR R/H - R+R WITH WHEEL REMOVED - Alfa - 166 - eLearn

3314716 - 4450D10 hub of one rear wheel, l/h or r/h - r+r with wheel removed

The bearings with the multi-polar magnetic codifier for A.B.S. active sensors should never be placed in direct contact with permanent magnets or electro-magnets.

Removing ( Refitting

) Position the vehicle on the ramp. - 4450B11 WHEEL (one) rear - R.R. . - 3310B48 rear brake disc - r r . 1. Undo the bolt (1a) and remove the rear wheel rpm sensor (1b) from its housing.2. Remove the rear wheel hub cover.3. Remove the bevel and undo the wheel hub nut.

1. Remove the rear wheel hub (1a) complete with bearing using tools (1b) and (1c).

	Name	Country
1b	Extractor	1.821.134.000

	Name	Country
1c	Counter weight	1.821.161.000

Remove the bearing outer track, as necessary, from the stub axle using a chisel.

Protective goggles should be worn for this operation.

1. Remove the bearing (1a) outer track using tools (1b) and (1c).

	Name	Country
1b	Extractor	1.840.005.200

	Name	Country
1c	Clamps	1.840.005.103

Refitting ( Removing

) 1. Fit the rear wheel hub (1a) complete with bearing using the tool (1b).

	Name	Country
1b	Tool for Extracting/Fitting	1.870.665.000

Tighten the rear wheel hub nut to the recommended torque.

	Fastening	Component	Ø	Value(daNm)
-	Nut	REAR WHEEL HUB	M24	30.4 - 33.6

1. Stake the nut as illustrated in the diagram using a chisel.

Fit the rear wheel hub cover.Replace the rear wheel rpm sensor in its housing and fix it using the bolt. - 3310B48 rear brake disc - r r . - 4450B11 WHEEL (one) rear - R.R. . Remove the car from the ramp. Check and if necessary adjust the wheel geometry values - 4450A40 rear wheel geometry - check using optical equipment .