194003938 - 1080CB EGR SOLENOID OPERATION CHECK
| CHECK TO BE PERFORMED | RESOLUTION IF THE CHECK IS NOT OK | |
|---|---|---|
| 1 | Press the START/STOP button and turn off the engine.Disconnect the cable loom connector from the EGR solenoid See L030 EGR SOLENOID VALVEPress the START/STOP button.Measure the voltage between Pin 1 of the wiring side connector and Earth. Ensure it is greater than 11V.Press the START/STOP button.Move on to Step 4 | Move on to Step 2 |
| 2 | In the engine compartment junction unit, remove fuse F11 (third in the lower row) See B001 ENGINE COMPARTMENT JUNCTION UNITPress the START/STOP button.Check the voltage between the fuse inlet contact and earth. Ensure it is greater than 11 V. | Replace the junction unit Op. 5505A13 ADDITIONAL JUNCTION UNIT IN ENGINE COMPARTMENT - R.R. |
| 3 | If fualts are present, repair or if necessary replace the electrical wiring between the engine compartment junction unit and the solenoid. See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENTThe test can be considered over | Replace the junction unit Op. 5505A13 ADDITIONAL JUNCTION UNIT IN ENGINE COMPARTMENT - R.R. |
| 4 | Disconnect the cable loom connector from engine management control unit connector B See M010 ENGINE MANAGEMENT CONTROL UNITPress the START/STOP button.Measure the voltage between Pin 2 of the EGR solenoid wiring side connector and Earth. Ensure it is less than 0.3 V. See L030 EGR SOLENOID VALVE | Repair or if necessary replace the electrical wiring between the engine control unit and the solenoid See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT |
| 5 | Press the START/STOP button. Measure the resistance between Pin 2 of the EGR solenoid wiring side connector and Earth. Ensure it is greater than 500 kOhm. See L030 EGR SOLENOID VALVE | Repair or if necessary replace the electrical wiring between the engine control unit and the solenoid See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT |
| 6 | Measure the resistance between Pin 2 of the EGR solenoid wiring side connector and Pin 60 of engine control unit wiring side connector B. Ensure it is less than 5 Ohms. See L030 EGR SOLENOID VALVE See M010 ENGINE MANAGEMENT CONTROL UNITReconnect the cable loom connectors to the EGR solenoid and the engine management control unit See L030 EGR SOLENOID VALVE See M010 ENGINE MANAGEMENT CONTROL UNIT | Repair or if necessary replace the electrical wiring between the engine control unit and the solenoid See E5050 DIESEL ENGINES ELECTRONIC MANAGEMENT |
| 7 | Replace the solenoid and check that the fault has disappeared Op. 1080C24 E.G.R. SYSTEM SOLENOID - R + R | Repair the original EGR solenoid and replace the engine management control unit Op. 1060G80 DIESEL ELECTRONIC INJECTION CONTROL UNIT - .R |