194000524 - 4110A30 SUPPORT WITH STEERING CONTROL SHAFTS - R+R
Removing
(
Refitting
)
Op. 5530B10 BATTERY - R+R Op. 5530B52 BATTERY SUPPORT/DRIP TRAY - R.R Op. 4110A10 STEERING WHEEL - R+R FOR REPLACEMENT OR CHECKS Op. 7040A26 STEERING COLUMN TRIM - R+R Op. 5550A10 STALK UNIT ASSEMBLY - R+R Op. 7040A30 LEFT LOWER DASHBOARD TRIM - R.R. Op. 5010C57 LEFT LOWER AIR DIFFUSER - R R Op. 5580C23 DRIVE SIDE KNEE PROTECTION AIR BAG MODULE R. R. | Position the steering wheel spokes in a position corresponding to driving in a straight line. |
| The bolt is the pre-treated type and it therefore cannot be reused when refitting. |
 | Avoid rotating the steering column until the steering column has been reconnected once again to the steering box making sure that the latter is positioned centrally. |
| Description | Connector | |
|---|---|---|
| - | Steering sensor | See K058 STEERING SENSOR |
Refitting
(
Removing
)
1. Place the support and steering control shafts (1a) in its housing and secure it tightening the nuts (1b) to the recommended torque.| Component | Fastening | dia | Value (daNm) | Validity |
|---|---|---|---|---|
| Support with steering control shafts. | Nut | M8 | (bodyshell side) 1.1 - 2.0 |
| Component | Fastening | dia | Value (daNm) | Validity |
|---|---|---|---|---|
| Steering column | Bolt (to be replaced) | M8 | (power assisted steering box side) 2.3 - 2.8 |
| The positioning of the steering column in relation to the pinion is determined by double levelling on the fork and on the pinion and by asymmetrical milling on the pinion. |
| If a new support and steering control shafts are fitted, remove the device preventing the rotation of the steering column. |
