198001935 - S019 FORECARRIAGE TRANSVERSE VIBRATIONS

Whilst driving, especially on unmade roads, there are transverse vibrations at the front section. This diagnosis can only be made later on.    See table S015 NOISE WHILST DRIVINGCarry out the latter first.
0PRELIMINARY CHECKSAll OKProblems encounteredOperation
Having carried out the road test, during the    See table S015 NOISE WHILST DRIVINGtransverse vibrations (shaking) are felt at the front end.Continue according to the circumstances in which the vibration occursEnd of diagnosisThe vibration is noticeable during take off and release.Move on to Step 4
The vibration is accompanied by noise over unmade roads.Move on to Step 2
1WHEEL SIDE CONSTANT VELOCITY JOINT CHECKAll OKProblems encounteredOperation
Raise the vehicle on a two column lift and check:- that the driveshaft-wheel side joint matching is correct;- that the seal is present.Move on to Step 2Incorrect matching.Replace the constant velocity joint and the driveshaft    Op. 2710A10 DRIVESHAFT WITH JOINTS (ONE), L/H OR R/H - R + R
Sealing ring missing.Replace the constant velocity joint and the driveshaft    Op. 2710A10 DRIVESHAFT WITH JOINTS (ONE), L/H OR R/H - R + R
2WHEEL SIDE JOINT CLEARANCE CHECKAll OKProblems encounteredOperation
Check that the clearance for the wheel side constant velocity joint is not too great.Move on to Step 3Excessive clearance compared with the opposite wheel side joint.Replace the wheel side constant velocity joint    Op. 2710A20 WHEEL SIDE CONSTANT VELOCITY JOINT (ONE), L/H OR R/H - R + R WITH DRIVESHAFT REMOVED - INCLUDES BOOT REPLACEMENT and carry out the correct greasing.
3WHEEL SIDE JOINT SEIZING CHECKAll OKProblems encounteredOperation
Rotate the wheel by hand and check that there is no seizing of the wheel side constant velocity joint.Move on to Step 4There is seizing of the wheel side joint.Replace the constant velocity joint    Op. 2710A20 WHEEL SIDE CONSTANT VELOCITY JOINT (ONE), L/H OR R/H - R + R WITH DRIVESHAFT REMOVED - INCLUDES BOOT REPLACEMENT and carry out the correct greasing.
4WHEEL SIDE JOINT TIGHTENING CHECKAll OKProblems encounteredOperation
Remove the left wheel    Op. 4450B02 LEFT FRONT WHEEL - R.R and/or the right one    Op. 4450B04 RIGHT FRONT WHEEL - R.R Check that the constant velocity joint fastening nut is tightened and that the staking is in place.Move on to Step 5Nut looseningReplace the nut, restore the torque tightening and stake    Op. 4450C32 ONE FRONT WHEEL HUB BEARING, LH OR RH - REPLACE
5CLUTCH PLATE CHECKAll OKProblems encounteredOperation
Check that there is no irregular wear on the surface of the clutch plate.Move on to Step 6Surface of the clutch plate worn unevenly.Replace the assembly    Op. 1810A20 CLUTCH - R + R
6All OKProblems encounteredOperation
Check that the fault is no longer present.End of diagnosisThe fault persists.The fault is due to another system (engine, gearbox, differential, suspension). Search for the cause in one of these systems, following the appropriate diagnostic procedures.