198000289 - 2710A10 DRIVESHAFT WITH JOINTS (ONE), L/H OR R/H - R + R

Removing ( Refitting )

The procedure for the left driveshaft is described below. For the right driveshaft, refer to    Op. 2710A14 RIGHT DRIVESHAFT WITH JOINTS AND INTERMEDIATE DRIVESHAFT - R+R because it can only be removed together with the intermediate driveshaft.

    Op. 3310A60 FRONT BRAKE PADS - REPLACE     Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.     Op. 0010T40 CHANGE MANUAL GEARBOX OIL 1. Remove the staking (1a), fit the tool (1b) and undo the wheel hub fixing nut.

Tool	Description	Function	Validity
1870815000	Counter-torque	Loosen/ tighten nut securing front drive shaft to wheel hub

1. Undo the bolt (1a) and remove the ABS rpm sensor (1b), move it aside.2. Undo the two bolts securing the shock absorber to the steering knuckle. 1. Unscrew the nut (1a), fit the tool (1b) and disconnect the steering link (1c) from the strut.

Tool	Description	Function	Validity
1871000700	Extractor	Extracting steering rod from strut

- Disconnect the strut from the driveshaft.1. Using a suitable tool, release and remove the driveshaft complete with joints. Refitting ( Removing ) - Place the driveshaft complete with joints in position.- Connect the steering link to the steering knuckle and tighten the nut to the specified torque.

Component	Fastening	dia	Value (daNm)	Validity
Steering rod to pillar	Nut	M10	3.6 ÷ 4.4

- Connect the shock absorber to the wheel strut using new bolts and tighten them to the recommended torque.

To tighten to torque, position the torque wrench on the nut and not on the bolt.

Component	Fastening	dia	Value (daNm)	Validity
Front shock absorber to wheel strut	Bolt (to be replaced)	M10	6.7 ÷ 7.3	1.4 16v1.9 JTD 8v

Component	Fastening	dia	Value (daNm)	Validity
Front shock absorber to wheel strut	Bolt (to be replaced)	M12	9.5 ÷ 10.5	1.9 JTD 16v

- Position the ABS rpm sensor in its housing and secure it using the bolt.- Tighten the new wheel hub securing nut to the recommended torque.

Component	Fastening	dia	Value (daNm)	Validity
Front wheel hub	Nut (to replace)	M24	6.6 ÷ 7.3 + 62° +/- 2°

1. Stake the nut.     Op. 3310A60 FRONT BRAKE PADS - REPLACE     Op. 0010T40 CHANGE MANUAL GEARBOX OIL     Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.