A002 ALARM AND CENTRAL LOCKING NOT ACTIVATED - Fiat - NUOVA BRAVO - eLearn

198001668 - A002 ALARM AND CENTRAL LOCKING NOT ACTIVATED

The alarm system comes on automatically the moment the doors are locked using the remote control.

0	PRELIMINARY CHECKS	ALL OK	PROBLEMS ENCOUNTERED	ACTION
		TEST RESULTS
	Check whether:- the doors lock mechanically using the key that comes with the vehicle- the remote controls are both working and transmit the RF codes- the time that the remote control buttons are pressed is correct and they have not been pressed too many times- remote control battery is run down; check the voltage of the remote control battery See Test 5580EA ANTI-THEFT DEVICE REMOTE CONTROL OPERATION CHECK	Move on to Step 2	1. The doors do not lock using the key2. The remote control is not working as it is faulty3. The remote control is not working as the rolling code is out of sync4. The transmitter battery has been changed and the rolling code is out of sync5. The remote control does not work in certain places where there is strong electro-magnetic interference6. The time the buttons in the remote control are pressed is too long or the remote control button is pressed too many times. The NBC system is in protection mode7. Remote control battery run down	1. Proceed as instructed See table P010 CENTRAL LOCKING NOT WORKING2. Replace the remote control3. Resynchronise code See Test 5580EA ANTI-THEFT DEVICE REMOTE CONTROL OPERATION CHECK4. Resynchronise code See Test 5580EA ANTI-THEFT DEVICE REMOTE CONTROL OPERATION CHECK5. It is not possible to carry out any type of operation. Carry out the test somewhere far away from anti-theft transmitters, hospitals, electric power stations, industrial zones, radio-television transmitters.6. Wait 30 seconds without pressing the buttons and try again7. Replace remote control battery
1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the Examiner diagnostic equipment to the diagnostic socket.Check the following at the alarm node:- that there are no faults;The presence of the alarm system in the parameters mode- that there are no errors in the control unit;- the programming status of the remote controls	Move on to Step 3	1. The remote control is not working due to lack of programming2. Remote control used does not conform.	1. Check the voltage of the remote control battery See Test 5580EA ANTI-THEFT DEVICE REMOTE CONTROL OPERATION CHECKand, if run down, replace it2. Carry out the remote control programming procedure3. Replace the remote controls, checking conformity
2	CORRECT OPERATION CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the fault is no longer present	End of diagnosis	The fault persists	Replace body computer Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.