198001677 - A032 ALARM DOES NOT GO OFF WITH BOOT RELEASE

When the opening of the boot is requested using the remote control, the alarm system does not switch off.

In operational mode, the system, on receiving the boot lid opening command, disables the volumetric external modules and the perimeter protection from the boot switch inlet.

		TEST RESULTS
1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the diagnostic equipment to the body computer node and check, in parameters mode, that the boot lid status (open or closed) is correctly received.Check the remote control button is working properly	Move on to Step 3	1. The status of the boot lid is not received.2. Remote control defective.	1. Move on to Step 22. Replace the remote control
2	ELECTRICAL CIRCUIT CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the electrical connection between the boot lid switch and the door control unit is not broken.	Move on to Step 3	Electrical connection interrupted	Restore the continuity of the electrical connection between the boot lid switch and the body computer node    See E7015 ALARM
3	COMPONENT OPERATION CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Disconnect the connector, body computer node side, and check for the presence of the boot lid open/closed signal    See E7015 ALARM	Move on to Step 4	Boot lid electric switch not working.	Replace the boot lid lock    Op. 7015B10 SINGLE TAILGATE LOCK - R+R OR REPAIR WITH PANEL/PROTECTION REMOVED
4	CORRECT OPERATION CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check that the fault is no longer present	End of diagnosis	The fault persists	Replace body computer    Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.