198001679 - A035 TILT SENSOR ALARM NOT WORKING

When the alarm is switched on using the remote control, the system is activated correctly but the anti-tilt sensor does not interveneThe sensor is connected to the body computer node through an A-Bus serial line.

		TEST RESULTS
1	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the Examiner diagnostic equipment to the diagnostic socket and check the following at the body computer node in parameters mode:- the presence of the tilt sensorIn errors mode:that there are no problems relating to the anti-tilt sensor	Move on to Step 2	Presence of faults	Proceed as instructed by the diagnostic equipment
2	ULTRASOUND SENSORS CHECK	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Check the anti-tilt sensor is correctly connected via the A-Bus serial line to the body computer    See E7015 ALARM	Move on to Step 3	Connections not correct	Restore the correct connections.
3	CHECK USING DIAGNOSTIC EQUIPMENT	ALL OK	PROBLEMS ENCOUNTERED	ACTION
	Connect the Examiner diagnostic equipment to the diagnostic socket and check the following at the body computer node. In active diagnosis:the operation of the volumetric modules	End of diagnosis	1. Anti-tilt sensor defective2. Body computer defective	1. Replace the anti-tilt and ultrasound sensors module.2. Replace body computer    Op. 5505A35 MAIN BODY COMPUTER/JUNCTION UNIT - R.R.