198001736 - H007 EXCESSIVE ROLLING/PITCHING - AT FRONT

		Test results
1	ROAD TEST TO EVALUATE ROLL/ PITCHING	All OK	Problems encountered	Operation
	Carry out a road test to evalute the rolling/pitching of the vehicle    See Test 44B ROAD TEST FOR ROLLING/PITCHING EVALUATION	End of diagnosis	1. Subjective judgement compared with reference vehicle 62. Subjective judgement compared with reference vehicle 5.53. Subjective judgement compared with reference vehicle 3-4	1. Acceptable performance of the vehicle2. Move on to Step 23. Move on to Step 4
2	END OF TRAVEL BUFFER CHECK	All OK	Problems encountered	Operation
	Raise the vehicle on a two-column lift and, raising the dust cover on the lower side of the support spring, check that the end of travel buffer does not show signs of deterioration.	Move on to Step 3	End of travel buffer deteriorated	Replace the end of travel buffer    Op. 4410A12 FRONT SUSPENSION DAMPER (ONE), LH OR RH - FOR MCPHERSON STRUT SYSTEM - INCLUDES DISMANTLING/REASSEMBLY OF ASSEMBLY AT BENCH - R.R
3	WISHBONE BUSH CHECK	All OK	Problems encountered	Operation
	Check the condition of the wishbone front and rear bushes. The guard under the engine must be removed in order to do this    Op. 7055B54 UNDER ENGINE PROTECTION/GUARD - R.R.	Move on to Step 4	1. Wishbone front bush deteriorated2. Wishbone rear bush deteriorated	1. Replace the lower wishbone    Op. 4410B40 LOWER TRACK CONTROL ARM (WITH BALLJOINT) FOR LEFT OR RIGHT FRONT SUSPENSION (ONE) - R+R - CHECK WHEEL GEOMETRY SEPARATELY 2. Replace the lower wishbone    Op. 4410B40 LOWER TRACK CONTROL ARM (WITH BALLJOINT) FOR LEFT OR RIGHT FRONT SUSPENSION (ONE) - R+R - CHECK WHEEL GEOMETRY SEPARATELY
4	SHOCK ABSORBER EFFICIENCY CHECK	All OK	Problems encountered	Operation
	Check the efficiency of the shock absorbers by carrying out manual compression manoeuvres (resting on the bonnet by the centre of the wheel), which should be carried out on both sides of the vehicle	Move on to Step 5	Sudden return without damping	Replace the shock absorber which is not working properly    Op. 4410A12 FRONT SUSPENSION DAMPER (ONE), LH OR RH - FOR MCPHERSON STRUT SYSTEM - INCLUDES DISMANTLING/REASSEMBLY OF ASSEMBLY AT BENCH - R.R
5	VEHICLE GEOMETRY CHECK	All OK	Problems encountered	Operation
	After replacing the shock absorbers, check the geometry	End of diagnosis	Geometry values do not conform	Restore the geometry to the correct values    Op. 4450A10 FRONT WHEEL GEOMETRY - CHECK USING OPTICAL EQUIPMENT - INCLUDES ADJUSTMENT IF NECESSARY