199002955 - D004 ENGINE NOT RUNNING SMOOTHLY

The customer complains that: Irregular engine operation, missing that can be reproduced
Test results
1MODE PARAMETERS CHECKAll OKProblems encounteredOperation
Select the following control unit at the diagnostic equipment: Marelli Diesel Injection 6F3 EOBD CAN (EP engine 1.3 JTD).Check the value of the following parameters:- Battery voltage    See Test 5530BB BATTERY VOLTAGE CHECK- Clutch pedal    See Test 1060GL CHECK OPERATION OF MAIN ENGINE CONTROL UNIT RELAY- Accelerator position 1 AD/C- Accelerator position 2 AD/C    See Test 1068AC ACCELERATOR PEDAL CHECKSMove on to Step 2
2POWER SUPPLY CIRCUIT CHECKAll OKProblems encounteredOperation
Check the condition of the fuel supply circuit and make sure that it is working properly    See Test 1040OA FUEL SUPPLY CIRCUIT CHECKMove on to Step 3
3MODE PARAMETERS CHECKAll OKProblems encounteredOperation
Select the following control unit at the diagnostic equipment: Marelli Diesel Injection 6F3 EOBD CAN (EP engine 1.3 JTD).Check the value of the following parameters:- Measured Diesel pressure    See Test 1060GH DIESEL PRESSURE CHECK- Pressure regulator opening (MPROP)    See Test 1060GR CHECK OPERATION OF FUEL PRESSURE SENSOR ON RAIL- Air temperature (debimeter)    See Test 1060GK CHECK CONTROL UNIT SOFTWARE AND HARDWARE- Diesel temperature    See Test 1060EA DIESEL TEMPERATURE CHECK- Coolant temperature    See Test 1060OE ENGINE COOLANT TEMPERATURE SENSOR OPERATION CHECK. Atmospheric pressure    See Test 1060GD ATMOSPHERIC PRESSURE CHECKMove on to Step 4
4INTAKE CIRCUIT CHECKAll OKProblems encounteredOperation
Check that the air intake/vacuum circuit is working properly    See Test 1048OA AIR INTAKE/VACUUM CIRCUIT CHECKMove on to Step 5
5PREHEATING RELAY ACTIVE DIAGNOSISAll OKProblems encounteredOperation
Carry out the active diagnosis of the preheating relay, checking that the result is positive
The check on the following system is only necessary if the outside temperature is below 0 °C.
End of diagnosisThe result of the active diagnosis is negativeMove on to Step 6
6GLOW HEATER PLUGS CHECKAll OKProblems encounteredOperation
Check that the glow heater plugs are working properly    See Test 5520CA CHECK GLOW PLUG OPERATIONEnd of diagnosis